Bipolar coordinates


Bipolar coordinates are a two-dimensional orthogonal coordinate system based on the Apollonian circles.. Confusingly, the same term is also sometimes used for two-center bipolar coordinates. There is also a third system, based on two poles.
The term "bipolar" is further used on occasion to describe other curves having two singular points, such as ellipses, hyperbolas, and Cassini ovals. However, the term bipolar coordinates is reserved for the coordinates described here, and never used for systems associated with those other curves, such as elliptic coordinates.

Definition

The system is based on two foci F1 and F2. Referring to the figure at right, the σ-coordinate of a point P equals the angle F1 P F2, and the τ-coordinate equals the natural logarithm of the ratio of the distances d1 and d2:
If, in the Cartesian system, the foci are taken to lie at and, the coordinates of the point P are
The coordinate τ ranges from to . The coordinate σ is only defined modulo , and is best taken to range from to π, by taking it as the negative of the acute angle F1 P F2 if P is in the lower half plane.

Proof that coordinate system is orthogonal

The equations for x and y can be combined to give
This equation shows that σ and τ are the real and imaginary parts of an analytic function of x+iy, which in turn proves that the curves of σ and τ intersect at right angles, i.e., that the coordinate system is orthogonal.

Curves of constant ''σ'' and ''τ''

The curves of constant σ correspond to non-concentric circles
that intersect at the two foci. The centers of the constant-σ circles lie on the y-axis. Circles of positive σ are centered above the x-axis, whereas those of negative σ lie below the axis. As the magnitude |σ| increases, the radius of the circles decreases and the center approaches the origin, which is reached when |σ| = π.
The curves of constant are non-intersecting circles of different radii
that surround the foci but again are not concentric. The centers of the constant-τ circles lie on the x-axis. The circles of positive τ lie in the right-hand side of the plane, whereas the circles of negative τ lie in the left-hand side of the plane. The τ = 0 curve corresponds to the y-axis. As the magnitude of τ increases, the radius of the circles decreases and their centers approach the foci.

Reciprocal relations

The passage from the Cartesian coordinates towards the bipolar coordinates can be done via the following formulas:
and
The coordinates also have the identities:
and

Scale factors

To obtain the scale factors for bipolar coordinates, we take the differential of the equation for, which gives
Multiplying this equation with its complex conjugate yields
Employing the trigonometric identities for products of sines and cosines, we obtain
from which it follows that
Hence the scale factors for σ and τ are equal, and given by
Many results now follow in quick succession from the general formulae for orthogonal coordinates.
Thus, the infinitesimal area element equals
and the Laplacian is given by
Expressions for,, and can be expressed obtained by substituting the scale factors into the general formulae found in orthogonal coordinates.

Applications

The classic applications of bipolar coordinates are in solving partial differential equations, e.g., Laplace's equation or the Helmholtz equation, for which bipolar coordinates allow a separation of variables. An example is the electric field surrounding two parallel cylindrical conductors with unequal diameters.
Polar plotters use bipolar coordinates to describe the drawing paths required to draw a target image.

Extension to 3-dimensions

Bipolar coordinates form the basis for several sets of three-dimensional orthogonal coordinates.