Wigner rotation


In theoretical physics, the composition of two non-collinear Lorentz boosts results in a Lorentz transformation that is not a pure boost but is the composition of a boost and a rotation. This rotation is called Thomas rotation, Thomas–Wigner rotation or Wigner rotation. The rotation was discovered by Llewellyn Thomas in 1926, and derived by Wigner in 1939. If a sequence of non-collinear boosts returns an object to its initial velocity, then the sequence of Wigner rotations can combine to produce a net rotation called the Thomas precession.
There are still ongoing discussions about the correct form of equations for the Thomas rotation in different reference systems with contradicting results. Goldstein:
Einstein's principle of velocity reciprocity reads
With less careful interpretation, the EPVR is seemingly violated in some models. There is, of course, no true paradox present.

Setup of frames and relative velocities between them

Two general boosts

When studying the Thomas rotation at the fundamental level, one typically uses a setup with three coordinate frames,. Frame has velocity relative to frame, and frame has velocity relative to frame.
The axes are, by construction, oriented as follows. Viewed from, the axes of and are parallel Also viewed from, the spatial axes of and are parallel This is an application of EVPR: If is the velocity of relative to, then is the velocity of relative to. The velocity makes the same angles with respect to coordinate axes in both the primed and unprimed systems. This does not represent a snapshot taken in any of the two frames of the combined system at any particular time, as should be clear from the detailed description below.
This is possible, since a boost in, say, the positive, preserves orthogonality of the coordinate axes. A general boost can be expressed as, where is a rotation taking the into the direction of and is a boost in the new. Each rotation retains the property that the spatial coordinate axes are orthogonal. The boost will stretch the by a factor, while leaving the and in place. The fact that coordinate axes are non-parallel in this construction after two consecutive non-collinear boosts is a precise expression of the phenomenon of Thomas rotation.
The velocity of as seen in is denoted, where ⊕ refers to the relativistic addition of velocity, given by
and
is the Lorentz factor of the velocity . The velocity can be thought of the velocity of a frame relative to a frame, and is the velocity of an object, say a particle or another frame relative to. In the present context, all velocities are best thought of as relative velocities of frames unless otherwise specified. The result is then the relative velocity of frame relative to a frame.
Although velocity addition is nonlinear, non-associative, and non-commutative, the result of the operation correctly obtains a velocity with a magnitude less than. If ordinary vector addition was used, it would be possible to obtain a velocity with a magnitude larger than. The Lorentz factor of both composite velocities are equal,
and the norms are equal under interchange of velocity vectors
Since the two possible composite velocities have equal magnitude, but different directions, one must be a rotated copy of the other. More detail and other properties of no direct concern here can be found in the main article.

Reversed configuration

Consider the reversed configuration, namely, frame moves with velocity relative to frame, and frame, in turn, moves with velocity relative to frame. In short, and by EPVR. Then the velocity of relative to is. By EPVR again, the velocity of relative to is then.
One finds. While they are equal in magnitude, there is an angle between them. For a single boost between two inertial frames, there is only one unambiguous relative velocity. For two boosts, the peculiar result of two inequivalent relative velocities instead of one seems to contradict the symmetry of relative motion between any two frames. Which is the correct velocity of relative to ? Since this inequality may be somewhat unexpected and potentially breaking EPVR, this question is warranted.

Formulation in terms of Lorentz transformations

Two boosts equals a boost and rotation

The answer to the question lies in the Thomas rotation, and that one must be careful in specifying which coordinate system is involved at each step. When viewed from, the coordinate axes of and are not parallel. While this can be hard to imagine since both pairs and have parallel coordinate axes, it is easy to explain mathematically.
Velocity addition does not provide a complete description of the relation between the frames. One must formulate the complete description in terms of Lorentz transformations corresponding to the velocities. A Lorentz boost with any velocity is given symbolically by
where the coordinates and transformation matrix are compactly expressed in block matrix form
and in turn, are column vectors, and is the Lorentz factor of velocity. The boost matrix is a symmetric matrix. The inverse transformation is given by
It is clear that to each admissible velocity there corresponds a pure Lorentz boost,
Velocity addition corresponds to the composition of boosts in that order. The acts on first, then acts on. Notice succeeding operators act on the left in any composition of operators, so should be interpreted as a boost with velocities then, not then. Performing the Lorentz transformations by block matrix multiplication,
the composite transformation matrix is
and in turn
Here is the composite Lorentz factor, and and are 3×1 column vectors proportional to the composite velocities. The 3×3 matrix will turn out to have geometric significance.
The inverse transformations are
and the composition amounts to a negation and exchange of velocities,
If the relative velocities are exchanged, looking at the blocks of, one observes the composite transformation to be the matrix transpose of. This is not the same as the original matrix, so the composite Lorentz transformation matrix is not symmetric, and thus not a single boost. This in turn translates to the incompleteness of velocity composition from the result of two boosts, symbolically;
To make the description complete, it is necessary to introduce a rotation, before or after the boost. This rotation is the Thomas rotation. A rotation is given by
where the 4×4 rotation matrix is
and is a 3×3 rotation matrix. In this article the axis-angle representation is used, and is the "axis-angle vector", the angle multiplied by a unit vector parallel to the axis. Also, the right-handed convention for the spatial coordinates is used, so that rotations are positive in the anticlockwise sense according to the right-hand rule, and negative in the clockwise sense. With these conventions; the rotation matrix rotates any 3d vector about the axis through angle anticlockwise, which has the equivalent effect of rotating the coordinate frame clockwise about the same axis through the same angle.
The rotation matrix is an orthogonal matrix, its transpose equals its inverse, and negating either the angle or axis in the rotation matrix corresponds to a rotation in the opposite sense, so the inverse transformation is readily obtained by
A boost followed or preceded by a rotation is also Lorentz transformation, since these operations leave the spacetime interval invariant. The same Lorentz transformation has two decompositions for appropriately chosen rapidity and axis-angle vectors;
and if these are two decompositions are equal, the two boosts are related by
so the boosts are related by a matrix similarity transformation.
It turns out the equality between two boosts and a rotation followed or preceded by a single boost is correct: the rotation of frames matches the angular separation of the composite velocities, and explains how one composite velocity applies to one frame, while the other applies to the rotated frame. The rotation also breaks the symmetry in the overall Lorentz transformation making it nonsymmetric. For this specific rotation, let the angle be and the axis be defined by the unit vector, so the axis-angle vector is.
Altogether, two different orderings of two boosts means there are two inequivalent transformations. Each of these can be split into a boost then rotation, or a rotation then boost, doubling the number of inequivalent transformations to four. The inverse transformations are equally important; they provide information about what the other observer perceives. In all, there are eight transformations to consider, just for the problem of two Lorentz boosts. In summary, with subsequent operations acting on the left, they are
Two boosts......split into a boost then rotation......or split into a rotation then boost.

Matching up the boosts followed by rotations, in the original setup, an observer in notices to move with velocity then rotate clockwise, and because of the rotation an observer in Σ′′ notices to move with velocity then rotate anticlockwise. If the velocities are exchanged an observer in notices to move with velocity then rotate anticlockwise, and because of the rotation an observer in notices to move with velocity then rotate clockwise.
The cases of rotations then boosts are similar. Matching up the rotations followed by boosts, in the original setup, an observer in notices to rotate clockwise then move with velocity, and because of the rotation an observer in notices to rotate anticlockwise then move with velocity. If the velocities are exchanged an observer in notices to rotate anticlockwise then move with velocity, and because of the rotation an observer in notices to rotate clockwise then move with velocity.

Finding the axis and angle of the Thomas rotation

The above formulae constitute the relativistic velocity addition and the Thomas rotation explicitly in the general Lorentz transformations. Throughout, in every composition of boosts and decomposition into a boost and rotation, the important formula
holds, allowing the rotation matrix to be defined completely in terms of the relative velocities and. The angle of a rotation matrix in the axis–angle representation can be found from the trace of the rotation matrix, the general result for any axis is. Taking the trace of the equation gives
The angle between and is not the same as the angle between and.
In both frames Σ and Σ′′, for every composition and decomposition, another important formula
holds. The vectors and are indeed related by a rotation, in fact by the same rotation matrix which rotates the coordinate frames. Starting from, the matrix rotates this into anticlockwise, it follows their cross product
defines the axis correctly, therefore the axis is also parallel to. The magnitude of this pseudovector is neither interesting nor important, only the direction is, so it can be normalized into the unit vector
which still completely defines the direction of the axis without loss of information.
The rotation is simply a "static" rotation and there is no relative rotational motion between the frames, there is relative translational motion in the boost. However, if the frames accelerate, then the rotated frame rotates with an angular velocity. This effect is known as the Thomas precession, and arises purely from the kinematics of successive Lorentz boosts.

Finding the Thomas rotation

In principle, it is pretty easy. Since every Lorentz transformation is a product of a boost and a rotation, the consecutive application of two pure boosts is a pure boost, either followed by or preceded by a pure rotation. Thus suppose
The task is to glean from this equation the boost velocity and the rotation from the matrix entries of. The coordinates of events are related by
Inverting this relation yields
or
Set Then will record the spacetime position of the origin of the primed system,
or
But
Multiplying this matrix with a pure rotation will not affect the zeroth columns and rows, and
which could have been anticipated from the formula for a simple boost in the -direction, and for the relative velocity vector
Thus given with, one obtains and by little more than inspection of. From, construct. The solution for is then
With the ansatz
one finds by the same means
Finding a formal solution in terms of velocity parameters and involves first formally multiplying, formally inverting, then reading off form the result, formally building from the result, and, finally, formally multiplying. It should be clear that this is a daunting task, and it is difficult to interpret/identify the result as a rotation, though it is clear a priori that it is. It is these difficulties that the Goldstein quote at the top refers to. The problem has been thoroughly studied under simplifying assumptions over the years.

Group theoretical origin

Another way to explain the origin of the rotation is by looking at the generators of the Lorentz group.

Boosts from velocities

The passage from a velocity to a boost is obtained as follows. An arbitrary boost is given by
where is a triple of real numbers serving as coordinates on the boost subspace of the Lie algebra spanned by the matrices
The vector
is called the boost parameter or boost vector, while its norm is the rapidity. Here is the velocity parameter, the magnitude of the vector.
While for one has, the parameter is confined within, and hence. Thus
The set of velocities satisfying is an open ball in and is called the space of admissible velocities in the literature. It is endowed with a hyperbolic geometry described in the linked article.

Commutators

The generators of boosts,, in different directions do not commute. This has the effect that two consecutive boosts is not a pure boost in general, but a rotation preceding a boost.
Consider a succession of boosts in the x direction, then the y direction, expanding each boost to first order
then
and the group commutator is
Three of the commutation relations of the Lorentz generators are
where the bracket is a binary operation known as the commutator, and the other relations can be found by taking cyclic permutations of x, y, z components.
Returning to the group commutator, the commutation relations of the boost generators imply for a boost along the x then y directions, there will be a rotation about the z axis. In terms of the rapidities, the rotation angle is given by
equivalently expressible as

Spacetime diagrams for non-collinear boosts

The familiar notion of vector addition for velocities in the Euclidean plane can be done in a triangular formation, or since vector addition is commutative, the vectors in both orderings geometrically form a parallelogram. This does not hold for relativistic velocity addition; instead a hyperbolic triangle arises whose edges are related to the rapidities of the boosts. Changing the order of the boost velocities, one does not find the resultant boost velocities to coincide.

Footnotes