CONTOUR


The COmet Nucleus TOUR was a NASA Discovery-class space probe that failed shortly after its July 2002 launch. It had as its primary objective close flybys of two comet nuclei with the possibility of a flyby of a third known comet or an as-yet-undiscovered comet.
The two comets scheduled to be visited were Encke and Schwassmann-Wachmann-3, and the third target was d'Arrest. It was hoped that a new comet would have been discovered in the inner Solar System between 2006 and 2008, in which case the spacecraft trajectory would have been changed if possible to rendezvous with the new comet. Scientific objectives included imaging the nuclei at resolutions of up to, performing spectral mapping of the nuclei at resolutions of up to, and obtaining detailed compositional data on gas and dust in the near-nucleus environment, with the goal of improving knowledge of the characteristics of comet nuclei.
After the solid rocket motor intended to inject the spacecraft into solar orbit was ignited on August 15, 2002, contact with the probe could not be re-established. Ground-based telescopes later found three objects along the course of the satellite, leading to the speculation that it had disintegrated. Attempts to contact the probe were ended on December 20, 2002. The probe thus accomplished none of its primary scientific objectives, but did prove some spaceflight technologies, such as the APL-developed non-coherent spacecraft navigation technique, which was later used on the New Horizons spacecraft.

Spacecraft

Design and construction

The CONTOUR spacecraft was constructed in-house at the Johns Hopkins University Applied Physics Laboratory. CONTOUR was shaped as an octagonal prism, measuring at tall and long, had a total fueled mass of at launch, not including the mass of the STAR 30 booster it was attached to, during the launch phase of the mission. The spacecraft was fitted with a whipple shield, similar to the one used on Stardust, on its leading face, designed with four layers of nextel fabric and seven layers of kevlar. The shield was built to allow the spacecraft to withstand the respective 28.2 and 14 km/s velocity flybys of comets Encke and Schwassmann-Wachmann-3, where the spacecraft would be subjected to numerous particles ejecting from the nuclei of the comets. Although mission scientists predicted that the spacecraft would take no significant damage during the Encke and Schwassmann-Wachmann-3 encounters, the shield and its prototypes were tested vigorously during the construction of the spacecraft, including one where a shield prototype was shot at with surrogate nylon particles. The results of the earlier tests allowed mission planners to determine a safe distance from which the CONTOUR would pass by comets targeted on the mission. Three of the four scientific instruments aboard the spacecraft are embedded within this heat shield.

Spacecraft subsystems

Power

Power for CONTOUR derives from solar cells, which are mounted onto the spacecraft, decorating the sides and rear and generating up to 670 watts of power. A nickel–cadmium battery designed to last up to nine ampere-hours was also installed aboard the spacecraft in the event that the solar cell system fails, or does not provide enough power for the spacecraft or its instruments to function.

Communications and data

Propulsion and guidance

Scientific payload

CONTOUR launched on a Delta 7425 on July 3, 2002, at 6:47:41 UT from Cape Canaveral Air Force Station. It was launched into a high-apogee Earth orbit with a period of 5.5 days. Following a series of phasing orbits, the Star 30 solid rocket motor was used to perform an injection maneuver on August 15, 2002, to put CONTOUR in the proper trajectory for an Earth flyby in August 15, 2003 followed by an encounter with comet Encke on November 12, 2003, at a distance of 100 to 160 km and a flyby speed of 28.2 km/s, 1.07 AU from the Sun and 0.27 AU from Earth. During the August 2002 injection maneuver, the probe was lost.
Three more Earth flybys would have followed, in August 14, 2004, February 10, 2005, and February 10, 2006. On June 18, 2006, CONTOUR would have encountered comet Schwassmann-Wachmann-3 at 14 km/s, 0.95 AU from the Sun and 0.33 AU from Earth. Two more Earth flybys were scheduled in February 2007 and 2008, and a flyby of comet d'Arrest might have occurred on 16 August 2008 at a relative velocity of 11.8 km/s, 1.35 AU from the Sun and 0.36 AU from Earth. All flybys would have had a closest encounter distance of about 100 km and would have occurred near the period of maximum activity for each comet. After the comet Encke encounter, CONTOUR might have been retargeted towards a new comet if one was discovered with the desired characteristics.

Investigation into failure

According to NASA: "An investigation board concluded that the most likely cause of the mishap was structural failure of the spacecraft due to plume heating during the solid-rocket motor burn. Alternate possible but less likely causes determined were catastrophic failure of the solid rocket motor, collision with space debris, and loss of dynamic control of the spacecraft."

Proposed reflight

After the loss of CONTOUR, a replacement spacecraft - CONTOUR 2 - was proposed, scheduled for launch in 2006. However, the replacement did not ultimately materialize.