The Alco 539T was a dieselprime mover built by the American Locomotive Company. This engine was also used as a stationary powerplant, used in pipelinepumping stations, tugboats and dredges. It has a straight-six, four-stroke design in a castblock which produced from. The engine has a bore of, and a stroke of. The 539 engine was built at Alco's Auburn, New York engine plant and later starting in September1949 in Canada. The 539T was equipped with the Buchi turbocharger, being made under license by the Elliott Manufacturing Company of Jeannette, Pennsylvania. The first 539T engines were used in S-2 switchers and DL-105 passenger locomotives built in September 1940. Alco locomotives using this engine include the S-2, S-4, RS-1, RSC-1, RSD-1, DL-105, DL-107, DL-108, DL-109, and DL-110. MLW locomotives using this engine include the S-2, S-4, S-7, S-12, RS-1, and RSC-13. An eight-cylinder inline version of the 539T was developed by Alco. This diesel engine developed from. It was never used in a locomotive, but a twin bank V-8 had been planned to be used in an early version of the “Black Maria” DL-202/DL-203 in response to EMD's FT locomotive. The inline 8-539T was used in stationary and marine applications. The 539 engine was developed in response to the perceived drawback that Alco's line of diesel switchers had a restricted field of vision because of the high hood. Both Baldwin and EMC were offering diesel switchers with a lower engine hood that the trainmen could see over. The 539 engine was developed from the 538 engine, both had the same cylinder dimensions. The engine base of the 538 was flat and rode on a flatunderframe. The change that the 539 offered was to lower the base of the engine into the frame. This was done with revised mounting lugs and a modified oil pan. The modified 538 became known as the 539 and the change allowed the engine hood to be lowered two feet three inches. A very similar engine developed for the United States Navy was the 540T. This engine used a welded block. The welded construction was required because the specified shock tolerance requirements prohibit the use of cast blocks. The Navy 540 was used in Patrol Boats, Mine Sweepers, Mine Layers, and tug boats.
