The Tunbridge Wells Sand Formation comprises complex cyclic sequences of siltstones with sandstones and clays, typically fining upwards, and is lithologically similar to the older Ashdown Formation. It has a total thickness typically in the region of about 75 m. However, near Haywards Heath borehole data has proven the formation to be up to 150m thick. In the western parts of the High Weald the Tunbridge Wells Sands can be divided into four separate divisions; the Lower Tunbridge Wells Sand, the Ardingly Sandstone Member, the Grinstead Clay Member, and the Upper Tunbridge Wells Sand.
Lower Tunbridge Wells Sand
The Lower Tunbridge Wells Sand shows the best cyclic fining up sequences in the formation. The division comprises mainly interbedded siltstones and silty sandstones and occurs up to 27m thick.
The Grinstead Clay comprises mudstones and silty mudstones with siltstone, ironstone and shelly limestone. This member is lithologically similar to the older Wadhurst Clay and also has weathered red mottled clays at its top. The formation is up to 20m thick but is only present around the border of East Sussex and West Sussex. It can be further subdivided into the Lower Grinstead Clay and Upper Grinstead Clay. These divisions are separated by a lenticular calcareous sandstone known as the Cuckfield Stone. This is probably best known as the strata in which Gideon Mantell discovered Iguanodon in the early 19th century.
Upper Tunbridge Wells Sand
The Upper Tunbridge Wells Sand is similar to the Lower Tunbridge Wells Sand. It comprises soft red and grey mottled silts and clays in its lower part, and alternating silts and silty clays with thin beds of sandstones. The base of the Tunbridge Wells Sand is marked by a distinct change from the predominantly argillaceous sediments of the Wadhurst Clay to siltstones and silty sands. This boundary is often indicated on maps by spring lines and seepages, where groundwater percolating through the permeable Tunbridge Wells Sand is forced to surface at the junction with the Wadhurst Clay. The top of the Tunbridge Wells Sand Formation is well defined in the southwest of East Sussex but is gradational elsewhere. In the area north of Brighton and west of Lewes the boundary is marked by a massive sandstone, though this is not seen anywhere else.
Engineering Geology
Landslips often occur at or close to the lower boundary of the Tunbridge Wells Sands, between it and the underlying Wadhurst Clay Formation. This is partly caused by the steep sided hill, valley and ravine topography of the High Weald and partly by the lithological variation between the formations and the presence of spring lines and seepages. When percolating groundwater in the permeable sandstones of the Tunbridge Wells Sands comes into contact with the upper impermeable clay beds of the Wadhurst Clay, it is forced to find alternative migration pathways to the surface. This results in the saturation and weakening of the upper portion of the Wadhurst Clay, increasing the chances of failure.