Thermophoresis


Thermophoresis is a phenomenon observed in mixtures of mobile particles where the different particle types exhibit different responses to the force of a temperature gradient. The term thermophoresis most often applies to aerosol mixtures, but may also commonly refer to the phenomenon in all phases of matter. The term Soret effect normally applies to liquid mixtures, which behave according to different, less well-understood mechanisms than gaseous mixtures. Thermophoresis may not apply to thermomigration in solids, especially multi-phase alloys.

Thermophoretic force

The phenomenon is observed at the scale of one millimeter or less. An example that may be observed by the naked eye with good lighting is when the hot rod of an electric heater is surrounded by tobacco smoke: the smoke goes away from the immediate vicinity of the hot rod. As the small particles of air nearest the hot rod are heated, they create a fast flow away from the rod, down the temperature gradient. They have acquired higher kinetic energy with their higher temperature. When they collide with the large, slower-moving particles of the tobacco smoke they push the latter away from the rod. The force that has pushed the smoke particles away from the rod is an example of a thermophoretic force.
Thermodiffusion is labeled "positive" when particles move from a hot to cold region and "negative" when the reverse is true. Typically the heavier/larger species in a mixture exhibit positive thermophoretic behavior while the lighter/smaller species exhibit negative behavior. In addition to the sizes of the various types of particles and the steepness of the temperature gradient, the heat conductivity and heat absorption of the particles play a role. Recently, Braun and coworkers have suggested that the charge and entropy of the hydration shell of molecules play a major role for the thermophoresis of biomolecules in aqueous solutions.
The quantitative description is given by:
particle concentration; diffusion coefficient; and the thermodiffusion coefficient. The quotient of both coefficients
is called Soret coefficient.
The thermophoresis factor has been calculated from molecular interaction potentials derived from known molecular models

Applications

The thermophoretic force has a number of practical applications. The basis for applications is that, because different particle types move differently under the force of the temperature gradient, the particle types can be separated by that force after they've been mixed together, or prevented from mixing if they're already separated.
Impurity ions may move from the cold side of a semiconductor wafer towards the hot side, since the higher temperature makes the transition structure required for atomic jumps more achievable. The diffusive flux may occur in either direction, dependent on the materials involved. Thermophoretic force has been used in commercial precipitators for applications similar to electrostatic precipitators. It is exploited in the manufacturing of optical fiber in vacuum deposition processes. It can be important as a transport mechanism in fouling. Thermophoresis has also been shown to have potential in facilitating drug discovery by allowing the detection of aptamer binding by comparison of the bound versus unbound motion of the target molecule. This approach has been termed microscale thermophoresis. Furthermore, thermophoresis has been demonstrated as a versatile technique for manipulating single biological macromolecules, such as genomic-length DNA, and HIV virus in micro- and nanochannels by means of light-induced local heating. Thermophoresis is one of the methods used to separate different polymer particles in field flow fractionation.

History

Thermophoresis in gas mixtures was first observed and reported by John Tyndall in 1870 and further understood by John Strutt in 1882. Thermophoresis in liquid mixtures was first observed and reported by Carl Ludwig in 1856 and further understood by Charles Soret in 1879.
James Clerk Maxwell wrote in 1873 concerning mixtures of different types of molecules :
It has been analyzed theoretically by Sydney Chapman.
Thermophoresis at solids interfaces was numerically discovered by Schoen et al. in 2006 and was experimentally confirmed by Barreiro et al.
Negative thermophoresis in fluids was first noticed in 1967 by Dwyer in a theoretical solution, and the name was coined by Sone. Negative thermophoresis at solids interfaces was first observed by Leng et al. in 2016.