Surface wave


In physics, a surface wave is a mechanical wave that propagates along the interface between differing media. A common example is gravity waves along the surface of liquids, such as ocean waves. Gravity waves can also occur within liquids, at the interface between two fluids with different densities. Elastic surface waves can travel along the surface of solids, such as Rayleigh or Love waves. Electromagnetic waves can also propagate as "surface waves" in that they can be guided along with a refractive index gradient or along an interface between two media having different dielectric constants. In radio transmission, a ground wave is a guided wave that propagates close to the surface of the Earth.

Mechanical waves

In seismology, several types of surface waves are encountered. Surface waves, in this mechanical sense, are commonly known as either Love waves or Rayleigh waves. A seismic wave is a wave that travels through the Earth, often as the result of an earthquake or explosion. Love waves have transverse motion, whereas Rayleigh waves have both longitudinal and transverse motion. Seismic waves are studied by seismologists and measured by a seismograph or seismometer. Surface waves span a wide frequency range, and the period of waves that are most damaging is usually 10 seconds or longer. Surface waves can travel around the globe many times from the largest earthquakes. Surface waves are caused when P waves and S waves come to the surface.
Examples are the waves at the surface of water and air. Another example is internal waves, which can be transmitted along the interface of two water masses of different densities.
In theory of hearing physiology, the traveling wave of Von Bekesy, resulted from an acoustic surface wave of the basilar membrane into the cochlear duct. His theory purported to explain every feature of the auditory sensation owing to these passive mechanical phenomena. Jozef Zwislocki, and later David Kemp, showed that that is unrealistic and that active feedback is necessary.

Electromagnetic waves

Ground wave refers to the propagation of radio waves parallel to and adjacent to the surface of the Earth, following the curvature of the Earth. This radiative ground wave is known as the Norton surface wave, or more properly the Norton ground wave, because ground waves in radio propagation are not confined to the surface. Another type of surface wave is the non-radiative, bound-mode Zenneck surface wave or Zenneck–Sommerfeld surface wave. The earth has one refractive index and the atmosphere has another, thus constituting an interface that supports the guided Zenneck wave's transmission. Other types of surface wave are the trapped surface wave, the gliding wave and Dyakonov surface waves propagating at the interface of transparent materials with different symmetry. Apart from these, various types of surface waves have been studied for optical wavelengths.

Radio propagation

Lower frequency radio waves, below 3 MHz, travel efficiently as ground waves. In ITU nomenclature, this includes : medium frequency, low frequency, very low frequency, ultra low frequency, super low frequency, extremely low frequency waves.
Ground propagation works because lower-frequency waves are more strongly diffracted around obstacles due to their long wavelengths, allowing them to follow the Earth's curvature. Ground waves propagate in vertical polarization, with their magnetic field horizontal and electric field vertical. With VLF waves, the ionosphere and earth's surface act as a waveguide.
Conductivity of the surface affects the propagation of ground waves, with more conductive surfaces such as sea water providing better propagation. Increasing the conductivity in a surface results in less dissipation. The refractive indices are subject to spatial and temporal changes. Since the ground is not a perfect electrical conductor, ground waves are attenuated as they follow the earth's surface. The wavefronts initially are vertical, but the ground, acting as a lossy dielectric, causes the wave to tilt forward as it travels. This directs some of the energy into the earth where it is dissipated, so that the signal decreases exponentially.
Most long-distance LF "longwave" radio communication is a result of groundwave propagation. Mediumwave radio transmissions, including AM broadcast band, travel both as groundwaves and, for longer distances at night, as skywaves. Ground losses become lower at lower frequencies, greatly increasing the coverage of AM stations using the lower end of the band. The VLF and LF frequencies are mostly used for military communications, especially with ships and submarines. The lower the frequency the better the waves penetrate sea water. ELF waves have even been used to communicate with deeply submerged submarines.
Ground waves have been used in over-the-horizon radar, which operates mainly at frequencies between 2–20 MHz over the sea, which has a sufficiently high conductivity to convey them to and from a reasonable distance. In the development of radio, ground waves were used extensively. Early commercial and professional radio services relied exclusively on long wave, low frequencies and ground-wave propagation. To prevent interference with these services, amateur and experimental transmitters were restricted to the high frequencies, felt to be useless since their ground-wave range was limited. Upon discovery of the other propagation modes possible at medium wave and short wave frequencies, the advantages of HF for commercial and military purposes became apparent. Amateur experimentation was then confined only to authorized frequencies in the range.
Mediumwave and shortwave reflect off the ionosphere at night, which is known as skywave. During daylight hours, the lower D layer of the ionosphere forms and absorbs lower frequency energy. This prevents skywave propagation from being very effective on mediumwave frequencies in daylight hours. At night, when the D layer dissipates, mediumwave transmissions travel better by skywave. Ground waves do not include ionospheric and tropospheric waves.
The propagation of sound waves through the ground taking advantage of the Earth's ability to more efficiently transmit low frequency is known as audio ground wave.

Microwave field theory

Within microwave field theory, the interface of a dielectric and conductor supports "surface wave transmission". Surface waves have been studied as part of transmission lines and some may be considered as single-wire transmission lines.
Characteristics and utilizations of the electrical surface wave phenomenon include:
The surface plasmon polariton is an electromagnetic surface wave that can travel along an interface between two media with different dielectric constants. It exists under the condition that the permittivity of one of the materials forming the interface is negative, while the other one is positive, as is the case for the interface between air and a lossy conducting medium below the plasma frequency. The wave propagates parallel to the interface and decays exponentially vertical to it, a property called evanescence. Since the wave is on the boundary of a lossy conductor and a second medium, these oscillations can be sensitive to changes to the boundary, such as the adsorption of molecules by the conducting surface.

Sommerfeld–Zenneck surface wave

The Sommerfeld–Zenneck wave or Zenneck wave is a non-radiative guided electromagnetic wave that is supported by a planar or spherical interface between two homogeneous media having different dielectric constants. This surface wave propagates parallel to the interface and decays exponentially vertical to it, a property known as evanescence. It exists under the condition that the permittivity of one of the materials forming the interface is negative, while the other one is positive, as for example the interface between air and a lossy conducting medium such as the terrestrial transmission line, below the plasma frequency. Its electric field strength falls off at a rate of e-αd/√d in the direction of propagation along the interface due to two-dimensional geometrical field spreading at a rate of 1/√d, in combination with a frequency-dependent exponential attenuation, which is the terrestrial transmission line dissipation, where α depends on the medium’s conductivity. Arising from original analysis by Arnold Sommerfeld and Jonathan Zenneck of the problem of wave propagation over a lossy earth, it exists as an exact solution to Maxwell's equations. The Zenneck surface wave, which is a non-radiating guided-wave mode, can be derived by employing the Hankel transform of a radial ground current associated with a realistic terrestrial Zenneck surface wave source. Sommerfeld-Zenneck surface waves predict that the energy decays as R−1 because the energy distributes over the circumference of a circle and not the surface of a sphere. Evidence does not show that in radio space wave propagation, Sommerfeld-Zenneck surfaces waves are a mode of propagation as the path-loss exponent is generally between 20 dB/dec and 40 dB/dec.

Standards and doctrines

;Zenneck, Sommerfeld, Norton, and Goubau
;Wait
;Others