Speed limits in Australia


Speed limits in Australia range from shared zones to. In the Northern Territory four highways have zones. Speed limit signage is in km/h since metrication on 1 July 1974. All speed limits are multiples of 10 km/h – the last digit in all speed signs is zero. Speed limits are set by state and territory legislation albeit with co-ordination and discussion between governments.

Common limits

Australian states and territories use two "default" speed limits. These apply automatically in the absence of 'posted' speed restriction signage. The two default speed limits are:
Common speed zones below the default built up area 50 km/h limit are:
Common speed zones above the default limits are:
The "END" speed limit sign is increasingly used throughout Australia to signal the end of a posted speed restriction, or built-up area "default" speed-limit leading to the jurisdiction's "rural" default speed limit. It contains the word "END" and a number in a black circle beneath this, representing the ceasing speed-limit. It is typically used where, according to AS1742.4 the road beyond has certain hazards such as hidden driveways, poor camber, soft edges and other hazards where the road authority feels a posted speed limit sign might be too dangerous or otherwise unwarranted. It is intended therefore to invoke particular caution. This sign is used as a direct replacement for the slash-through speed derestriction signs common in Europe and elsewhere.
Speed limits are enforced in all areas of the country. Tolerance ranges from 3% to 10% in most states but only 3 km/h in Victoria, an issue that has caused much controversy in that state, especially in light of the fact that earlier Australian Design Rules specified that vehicle speedometers may have up to 10% leeway in accuracy. This was updated in 2006 to require that the "speed indicated shall not be less than the true speed of the vehicle." Detection measures used are radar, LIDAR, fixed and mobile speed cameras, Vascar, pacing and aircraft.

Default speed limits by state and territory

Despite introduction of model national road rules by the states in 1999, Western Australia and the Northern Territory retain different default speed limits. The table below indicates the default speed limits along with typical school zone limits and the highest zone in each locality.
In the external territories, and in some special cases, the speed limits may differ significantly from those found across the rest of the nation.
State / territorySchool zoneBuilt-up areaRural areaHighest speed zone
Australian Road Rulesnumber on school zone sign50100number on speed-limit sign
Australian Capital Territory4050100100
New South Wales40 on all roads 40 km/h or more
30 in designated 30 km/h zones in Manly and Liverpool
50100110
Northern Territory4060110130
Queensland40 on roads 70 km/h or less
60 on roads 80 km/h and some 90/100 km/h
80 on roads 110 km/h and some 90/100 km/h
50100110
South Australia25 on roads 60 km/h or less50100110
Tasmania40 on roads 70 km/h or less
60 on roads 80 km/h or more
50100110
Victoria40 on roads 70 km/h or less
60 on roads 80 km/h or more
50100110
Western Australia40 on roads 70 km/h or less
60 on roads with 80 km/h or 90 km/h
50110110
External territories
Christmas Island40409090
Cocos Islands--305050
Norfolk Island3030 - Kingston Foreshore
40 - Burnt Pine Central Business District
30 - Norfolk Island National Park
50 - Other Areas
50
Special cases
Lord Howe Island------25

Signage

Historical limits

Historically, Australia operated a simple speed limit system of urban and rural default limits, denoted in miles per hour. As part of metrication in 1974, speed limits and speed advisories were converted into kilometres per hour, rounded to the nearest 10 km/h, leading to small discrepancies in speed limits. Signage changed from a North American-style black and white textual sign to a design based on metric signage in use in New Zealand with black number in red annulus on white, itself a derivative of the European standard number in red circle design.

Urban limits

The urban default, which prior to the 1930s was, applied to any "built up area", usually defined by the presence of street lighting. This limit was progressively increased to over the next 30 years by each of the states and territories, with New South Wales being the last to change in May 1964. South Australia adopted on 30 November 1950 along with the "new short-right hand turn".
Metrication led to the default urban limits of being converted to 60 km/h, an increase of.
In the late 1990s and early 2000s, the urban default limit was progressively lowered to nationally for reasons of road, and especially pedestrian, safety. However, many existing roads, especially subarterial roads in urban areas, have had limits posted on them. Queensland's Manual of Uniform Traffic Control Devices states that is the general minimum speed limit for traffic-carrying roads. The Northern Territory has retained the limit; however, is also a common speed limit.

Rural limits

Outside of built up areas, a prima facie speed limit applied. In New South Wales and Victoria, speed limit was 50 miles per hour. In the 1970s however, most state speed limits were gradually replaced by absolute limits. An absolute speed limit of was introduced to Victoria in 1971, as a trial. This was subsequently reduced to in late 1973. South Australia introduced an absolute speed limit of in 1974.
With metrication in 1974, the rural defaults of and became and respectively. The 50 mph limit in New South Wales became a limit of 80 km/h.
New South Wales introduced an absolute speed limit of in 1979, replacing the limit of The Northern Territory introduced an absolute speed limit of in 2007, along with zones on the Territory's four major highways.

NT open speed limits

The Northern Territory had no blanket speed limits outside major towns until January 2007, when a general rural speed limit of was introduced, although four major highways had higher zones. Speed-limit advocates note that the per-capita fatality rate in 2006 was the highest in the OECD and twice the Australian average. In 2009, the opposition unsuccessfully sought the removal of the limits on three out of the four highways where it applied, arguing that total fatalities in the Northern Territory had increased significantly during the first two years of the speed limit. In argument against the motion, the government provided more detailed statistics than normally published; these statistics showed a reduction in fatalities along the highways where limits were introduced. In 2011 the opposition argued for a return to "open speed limits"
. For the 2012 election the Country Liberals' transport policy promised an evidence-based approach. After winning government, de-restriction of Stuart Highway was proposed; a planned 12-month de-restriction was initiated on 1 February 2014. The trial on of Stuart Highway was expanded later in the year to another, and continued indefinitely in January 2015 during a review of the initial results since "in the first 11 months, there were no recorded fatalities." From September 2015, a stretch of Stuart Highway between Barrow Creek and Alice Springs had speed limits removed for a 12-month trial. speed limits were restored on 20 November 2016 due to the electoral loss of the Country Liberal Party.

Derestriction signs in NSW

Often the start of rural default 'limits' or prima facie allowances were signalled by use of the speed derestriction sign, catalogued R4-2 in AS1742.4. . The speed derestriction sign had developed 'different meaning' over time at state and territory level, although its contract-meaning under "The United Nations Convention on Road Traffic, Signs & Signals" where the sign is catalogued "C,17a", is; "End of all local prohibitions imposed on moving vehicles" and has never changed. In the Northern Territory, they designated the end of speed restrictions. In Victoria and Western Australia they meant that the rural default speed limit applied, whilst in New South Wales, they indicated that the prima facie limit applied.
New South Wales's prima facie limit, often signed by derestriction signs, was only enforced in cases where a driver's speed could be demonstrated to be excessive or dangerous in the context of prevailing road conditions. This was somewhat similar in principle to "reasonable and prudent" limits in other jurisdictions. This led to the widespread but misleading belief that no limit applied, and that derestriction signs indicated an "unlimited" limit. This belief, coupled with repeated studies showing 85th percentile speeds in excess of on major routes, comparatively high road tolls, difficulty in prosecuting speeding offences, and the variance in meaning of the derestriction sign across states, led New South Wales to harmonise its rural default limit to in 1978. The use of derestriction signs in New South Wales was officially discouraged, and on state controlled routes, signs were progressively used instead.