Shellac


Shellac is a resin secreted by the female lac bug on trees in the forests of India and Thailand. It is processed and sold as dry flakes and dissolved in alcohol to make liquid shellac, which is used as a brush-on colorant, food glaze and wood finish. Shellac functions as a tough natural primer, sanding sealant, tannin-blocker, odour-blocker, stain, and high-gloss varnish. Shellac was once used in electrical applications as it possesses good insulation qualities and it seals out moisture. Phonograph and 78 rpm gramophone records were made of it until they were replaced by vinyl long-playing records from the 1950s onwards.
From the time it replaced oil and wax finishes in the 19th century, shellac was one of the dominant wood finishes in the western world until it was largely replaced by nitrocellulose lacquer in the 1920s and 1930s.

Etymology

Shellac comes from shell and lac, a calque of French laque en écailles, "lac in thin pieces", later gomme-laque, "gum lac". Most European languages have borrowed the word for the substance from English or from the German equivalent Schellack.

Production

Shellac is scraped from the bark of the trees where the female lac bug, Kerria lacca, secretes it to form a tunnel-like tube as it traverses the branches of the tree. Though these tunnels are sometimes referred to as "cocoons", they are not cocoons in the entomological sense. This insect is in the same superfamily as the insect from which cochineal is obtained. The insects suck the sap of the tree and excrete "sticklac" almost constantly. The least-coloured shellac is produced when the insects feed on the kusum tree.
The number of lac bugs required to produce of shellac has variously been estimated as,, or. The root word lakh is a unit in Indian numbering system for and presumably refers to the huge numbers of insects that swarm on host trees, up to 150 per square inch.
The raw shellac, which contains bark shavings and lac bugs removed during scraping, is placed in canvas tubes and heated over a fire. This causes the shellac to liquefy, and it seeps out of the canvas, leaving the bark and bugs behind. The thick, sticky shellac is then dried into a flat sheet and broken into flakes, or dried into "buttons", then bagged and sold. The end-user then crushes it into a fine powder and mixes it with ethyl alcohol before use, to dissolve the flakes and make liquid shellac.
Liquid shellac has a limited shelf life, so is sold in dry form for dissolution before use. Liquid shellac sold in hardware stores is often marked with the production date, so the consumer can know whether the shellac inside is still good. Some manufacturers have ceased labeling shellac with the production date, but the production date may be discernible from the production lot code. Alternatively, old shellac may be tested to see if it is still usable: a few drops on glass should quickly dry to a hard surface. Shellac that remains tacky for a long time is no longer usable. Storage life depends on peak temperature, so refrigeration extends shelf life.
The thickness of shellac is measured by the unit "pound cut", referring to the amount of shellac flakes dissolved in a gallon of denatured alcohol. For example: a 1-lb. cut of shellac is the strength obtained by dissolving one pound of shellac flakes in a gallon of alcohol. Most pre-mixed commercial preparations come at a 3-lb. cut. Multiple thin layers of shellac produce a significantly better end result than a few thick layers. Thick layers of shellac do not adhere to the substrate or to each other well, and thus can peel off with relative ease; in addition, thick shellac will obscure fine details in carved designs in wood and other substrates.
Shellac naturally dries to a high-gloss sheen. For applications where a flatter sheen is desired, products containing amorphous silica, such as "Shellac Flat", may be added to the dissolved shellac.
Shellac naturally contains a small amount of wax, which comes from the lac bug. In some preparations, this wax is removed. This is done for applications where the shellac will be coated with something else, so the topcoat will adhere. Waxy shellac appears milky in liquid form, but dries clear.

Colours and availability

Shellac comes in many warm colours, ranging from a very light blonde to a very dark brown, with many varieties of brown, yellow, orange and red in between. The colour is influenced by the sap of the tree the lac bug is living on and by the time of harvest. Historically, the most commonly sold shellac is called "orange shellac", and was used extensively as a combination stain and protectant for wood panelling and cabinetry in the 20th century.
Shellac was once very common anywhere paints or varnishes were sold. However, cheaper and more abrasion- and chemical-resistant finishes, such as polyurethane, have almost completely replaced it in decorative residential wood finishing such as hardwood floors, wooden wainscoting plank panelling, and kitchen cabinets. These alternative products, however, must be applied over a stain if the user wants the wood to be coloured; clear or blonde shellac may be applied over a stain without affecting the colour of the finished piece, as a protective topcoat. "Wax over shellac" is often regarded as a beautiful, if fragile, finish for hardwood floors. Luthiers still use shellac to French polish fine acoustic stringed instruments, but it has been replaced by synthetic plastic lacquers and varnishes in many workshops, especially high-volume production environments.
Shellac dissolved in alcohol, typically more dilute than French-Polish, is now commonly sold as "sanding sealer" by several companies. It is used to seal wooden surfaces, often as preparation for a final more durable finish; it reduces the amount of final coating required by reducing its absorption into the wood.

Properties

Shellac is a natural bioadhesive polymer and is chemically similar to synthetic polymers, and thus can be considered a natural form of plastic. It can be turned into a moulding compound when mixed with wood flour and moulded under heat and pressure methods, so it can also be classified as thermoplastic.
Shellac scratches more easily than most lacquers and varnishes, and application is more labour-intensive, which is why it has been replaced by plastic in most areas. But damaged shellac can easily be touched up with another coat of shellac because the new coat merges with and bonds to the existing coat. Shellac is much softer than Urushi lacquer, for instance, which is far superior with regard to both chemical and mechanical resistance.
Shellac is soluble in alkaline solutions such as ammonia, sodium borate, sodium carbonate, and sodium hydroxide, and also in various organic solvents. When dissolved in de-natured alcohol or ethanol, shellac yields a coating of good durability and hardness.
Upon mild hydrolysis shellac gives a complex mix of aliphatic and alicyclic hydroxy acids and their polymers that varies in exact composition depending upon the source of the shellac and the season of collection. The major component of the aliphatic component is aleuritic acid, whereas the main alicyclic component is shellolic acid.
Shellac is UV-resistant, and does not darken as it ages.

History

The earliest written evidence of shellac goes back years, but shellac is known to have been used earlier. According to the ancient Indian epic poem, the Mahabharata, an entire palace was built out of dried shellac.
Shellac was in rare use as a dyestuff for as long as there was a trade with the East Indies. Merrifield cites 1220 for the introduction of shellac as an artist's pigment in Spain. Lapis lazuli, an ultramarine pigment from Afghanistan, was already being imported long before this.
The use of overall paint or varnish decoration on large pieces of furniture was first popularised in Venice. There are a number of 13th-century references to painted or varnished cassone, often dowry cassone that were made deliberately impressive as part of dynastic marriages. The definition of varnish is not always clear, but it seems to have been a spirit varnish based on gum benjamin or mastic, both traded around the Mediterranean. At some time, shellac began to be used as well. An article from the Journal of the American Institute of Conservation describes using infrared spectroscopy to identify shellac coating on a 16th-century cassone. This is also the period in history where "varnisher" was identified as a distinct trade, separate from both carpenter and artist.
Another use for shellac is sealing wax. Woods's The Nature and Treatment of Wax and Shellac Seals discusses the various formulations, and the period when shellac started to be added to the previous beeswax recipes.
The "period of widespread introduction" would seem to be around 1550 to 1650, when the substance moved from being a rarity on highly decorated pieces to being described in the standard texts of the day.

Uses

Historical

In the early- and mid-twentieth century, orange shellac was used as a one-product finish on decorative wood panelling used on walls and ceilings in homes, particularly in the US. In the American South, use of knotty pine plank panelling covered with orange shellac was once as common in new construction as drywall is today. It was also often used on kitchen cabinets and hardwood floors, prior to the advent of polyurethane.
Until the advent of vinyl, most gramophone records were pressed from shellac compounds. From 1921 to 1928, tons of shellac were used to create 260 million records for Europe. In the 1930s, it was estimated that half of all shellac was used for gramophone records. Use of shellac for records was common until the 1950s and continued into the 1970s in some non-Western countries.
Until recent advances in technology, shellac was the only glue used in the making of ballet dancers' pointe shoes, to stiffen the box to support the dancer en pointe. Many manufacturers of pointe shoes still use the traditional techniques, and many dancers use shellac to revive a softening pair of shoes.
Shellac was historically used as a protective coating on paintings.
Sheets of Braille were coated with shellac to help protect them from wear due to being read by hand.
Shellac was used from the mid-nineteenth century to produce small moulded goods such as picture frames, boxes, toilet articles, jewelry, inkwells and even dentures. Advances in plastics have rendered shellac obsolete as a moulding compound.
Shellac was used both in the field and laboratory to glue and stabilise dinosaur bones until about the mid-1960s. While effective at the time, the long-term negative effects of shellac on dinosaur bones and other fossils is debated, and shellac is very rarely used by professional conservators and fossil preparators today.
Shellac was used for fixing inductor, motor, generator and transformer windings. It was applied directly to single-layer windings in an alcohol solution. For multi-layer windings, the whole coil was submerged in shellac solution, then drained and placed in a warm place to allow the alcohol to evaporate. The shellac locked the wire turns in place, provided extra insulation, prevented movement and vibration and reduced buzz and hum. In motors and generators it also helps transfer force generated by magnetic attraction and repulsion from the windings to the rotor or armature. In more recent times, shellac has been replaced in these applications by synthetic resins such as polyester resin. Some applications use shellac mixed with other natural or synthetic resins, such as pine resin or phenol-formaldehyde resin, of which Bakelite is the best known, for electrical use. Mixed with other resins, barium sulfate, calcium carbonate, zinc sulfide, aluminium oxide and/or cuprous carbonate, shellac forms a component of heat-cured capping cement used to fasten the caps or bases to the bulbs of electric lamps.

Current

It is the central element of the traditional "French polish" method of finishing furniture, fine string instruments, and pianos.
Shellac, edible, is used as a glazing agent on pills and sweets, in the form of pharmaceutical glaze. Because of its acidic properties, shellac-coated pills may be used for a timed enteric or colonic release. Shellac is used as a 'wax' coating on citrus fruit to prolong its shelf/storage life. It is also used to replace the natural wax of the apple, which is removed during the cleaning process. When used for this purpose, it has the food additive E number E904.
Shellac coating applied with either a standard or modified Huon-Stuehrer nozzle, can be economically micro-sprayed onto various smooth sweets, such as chocolate coated peanuts. Irregularities on the surface of the product being sprayed typically result in the formation of unsightly aggregates which precludes the use of this technique on foods such as walnuts or raisins.
Shellac is an odour and stain blocker and so is often used as the base of "solves all problems" primers. Although its durability against abrasives and many common solvents is not very good, shellac provides an excellent barrier against water vapour penetration. Shellac-based primers are an effective sealant to control odours associated with fire damage.
Shellac has traditionally been used as a dye for cotton and, especially, silk cloth in Thailand, particularly in the north-eastern region. It yields a range of warm colours from pale yellow through to dark orange-reds and dark ochre. Naturally dyed silk cloth, including that using shellac, is widely available in the rural northeast, especially in Ban Khwao District, Chaiyaphum province. The Thai name for the insect and the substance is "khrang".
Wood finish
Wood finishing is one of the most traditional and still popular uses of shellac mixed with solvents or alcohol. This dissolved shellac liquid, applied to a piece of wood, is an evaporative finish: the alcohol of the shellac mixture evaporates, leaving behind a protective film.
Shellac as wood finish is natural and non-toxic in its pure form. A finish made of shellac is UV-resistant. For water-resistance and durability, it does not keep up with synthetic finishing products.
Because it is compatible with most other finishes, shellac is also used as a barrier or primer coat on wood to prevent the bleeding of resin or pigments into the final finish, or to prevent wood stain from blotching.

Other

Shellac is used: