Ranger 3


Ranger 3 was a space exploration mission conducted by NASA to study the Moon. The Ranger 3 robotic spacecraft was launched January 26, 1962 as part of the Ranger program. Due to a series of malfunctions, the spacecraft missed the Moon by and entered a heliocentric orbit.
The Ranger 3 space probe was designed to transmit pictures of the lunar surface during a period of 10 minutes of flight prior to impacting on the Moon, to rough-land a seismometer capsule on the Moon, to collect gamma-ray data in flight, to study radar reflectivity of the lunar surface, and to continue testing of the Ranger program for development of lunar and interplanetary spacecraft.

Spacecraft design

Ranger 3 was the first of the Block II Ranger designs. The basic vehicle was 3.1 m high and consisted of a lunar capsule covered with a balsa wood impact-limiter, 650 mm in diameter, a mono-propellant mid-course motor, a retrorocket with a thrust of 5080 pounds force, and a gold- and chrome-plated hexagonal base 1.5 m in diameter. A large high-gain dish antenna was attached to the base. Two wing-like solar panels were attached to the base and deployed early in the flight. Power was generated by 8680 solar cells contained in the solar panels which charged an 11.5 kg 1 kW·h capacity AgZn launching and backup battery. Spacecraft control was provided by a solid-state computer and sequencer and an earth-controlled command system. Attitude control was provided by Sun and Earth sensors, gyroscopes, and pitch and roll jets. The telemetry system aboard the spacecraft consisted of two 960 MHz transmitters, one at 3 W power output and the other at 50 mW power output, the high-gain antenna, and an omnidirectional antenna. White paint, gold and chrome plating, and a silvered plastic sheet encasing the retrorocket furnished thermal control.
During prelaunch preparations for Ranger 1, the spacecraft's timer had accidentally been started which led to the deployment of the solar panels inside the payload shroud. It was decided that ground testing of the onboard instruments would not be done on the Block II spacecraft because they had a functional midcourse correction engine and if a similar incident happened with them, the squibs and pyrotechnics used to deploy the solar panels could inadvertently ignite the propellants in the onboard engine, which could result in the explosion of the spacecraft on the pad and possibly take the entire launch vehicle with it. JPL officials announced that factory testing of the Ranger's systems was sufficient to root out any problems and any hardware which failed to pass the tests was not fit to fly.
The experimental apparatus included: a vidicon television camera, which employed a scan mechanism that yielded one complete frame in 10 s; a gamma-ray spectrometer mounted on a 1.8 m boom; a radar altimeter; and a seismometer to be rough-landed on the lunar surface. The seismometer was encased in the lunar capsule along with an amplifier, a 50 mW transmitter, voltage control, a turnstile antenna, and six silver-cadmium batteries capable of operating the lunar capsule transmitter for 30 days, all designed to land on the Moon at 130 to 160 km/h. The radar altimeter would be used for reflectivity studies, but was also designed to initiate capsule separation and ignite the retrorocket.

Mission

Preparation for Ranger 3 was complicated by developmental issues with the Agena B stage, which had failed to operate correctly on Rangers 1-2. Agena was primarily the domain of the U.S. Air Force, who intended to use it for military payloads, and NASA had originally assumed it would begin flying in late 1960 or early 1961 by which time any developmental issues with the stage could be weeded out. However, Agena B ended up taking longer to put into service than originally anticipated and its performance also turned out to be somewhat less than expected, which forced some of the planned experiments on the Block II Rangers to be cancelled. While the Thor-Agena B had begun flying in October 1960, the Atlas-Agena B did not make its maiden voyage until July 1961, meaning that Ranger 1 was only the second time this launch vehicle combination been flown. This delay was explained by the fact that Air Force programs such as MIDAS were taking much longer to develop than Ranger. In addition, as 1961 ended, Agena Bs had malfunctioned no less than seven times.
Major General Osmond Ritland, Commander of the Air Force Space Systems Division in Inglewood, California, promised NASA that all problems with Agena would be corrected and, because they also affected DoD programs, the issue was being taken "quite seriously". Among other changes made would be a thorough review of all Lockheed field operating equipment and procedures. In addition, an effort would be made to ensure that checkout procedures on U.S. Air Force and NASA Agenas were identical and any differences in them eliminated.
The mission was designed to boost towards the Moon by an Atlas/Agena, undergo one mid-course correction, and impact the lunar surface. At the appropriate altitude, the capsule was to separate and the retrorockets ignite to cushion the landing. A malfunction in the booster guidance system resulted in excessive spacecraft speed. Reversed command signals caused the spacecraft to pitch in the wrong direction and the TM antenna to lose earth acquisition, and mid-course correction was not possible. Finally, a spurious signal during the terminal maneuver prevented transmission of useful TV pictures. Ranger 3 missed the Moon by approximately 36,800 km on January 28 and is now in a heliocentric orbit. Some useful engineering data were obtained from the flight.
In mid-December 1961, Atlas 121D and Agena 6003 arrived at Cape Canaveral and were erected on LC-12. On January 18, 1962, Ranger 3 was stacked atop the booster, but the following day attempted fueling of the Atlas went awry when a tear was found in the intermediate bulkhead separating the LOX and RP-1 tanks. This would mean that the launch vehicle would have to be taken down from the pad for repairs, delaying the launch an entire month. However, Air Force and Convair officials instead suggested the novel solution of doing the repairs right there on LC-12. The Atlas's sustainer engine was removed and lowered into the flame deflector pit and wooden scaffolding installed so that technicians could go up into the RP-1 tank, remove the damaged intermediate bulkhead, and replace it. By January 26, repairs were completed.
This was the first American attempt to achieve impact on the lunar surface. The Block II Ranger spacecraft carried a TV camera that used an optical telescope that would allow imaging down to about 24 kilometers above the lunar surface during the descent. The main bus also carried a 42.6-kilogram instrument capsule that would separate from the bus at 21.4 kilometers altitude and then independently impact on the Moon. Protected by a balsa-wood outer casing, the capsule was designed to bounce several times on the lunar surface before coming to rest. The primary onboard instrument was a seismometer.
Liftoff took place at 3:30 PM EST on January 26, an hour and 15 minutes before the launch window closed, after which Ranger 3 could not have been launched for another month.
At T+49 seconds into launch, the pulse beacon on the Atlas guidance system ceased operating, which prevented the transmission of any steering or cutoff discreets for the remainder of the launch. Backup commands from the missile programmer were used to perform booster jettison and Agena separation, but without the guidance program, it was impossible to perform the necessary fine tuning maneuvers to put the Atlas on the correct flight path. SECO occurred due to propellant depletion rather than a programmed cutoff command, causing the Agena and probe to be accelerated higher and faster than planned. Even worse, equipment at a Florida tracking station malfunctioned and picked up Ranger 3's orbital parameters 5 minutes late. Meanwhile, the Agena restarted and sent the probe out of Earth orbit, but another error in its guidance program resulted in a further erroneous trajectory. This ensured that the spacecraft reached the Moon 14 hours early and missed it by 36,793 kilometers on January 28.
Although impact with the Moon was no longer possible, Ranger 3 could still be used for deep-space studies. Commands were issued to unfurl the camera boom and on the 28th, a fixed-up computer program was uploaded. But midway through this maneuver, the probe's signal strength began to weaken and the computer system completely failed. The TV camera transmitted images, but as the antenna was now pointed away from Earth, they were extremely weak and noisy. It was possible to see the reference crosses on the camera lens, illuminated by reflected sunlight from the probe's chassis, but the Moon was not visible. With the computer dead, Ranger 3 became completely unresponsive to any ground commands and the Earth and Sun sensors were rendered useless. The gyroscopes continued to maneuver the probe and ground controllers momentarily reacquired a lock on the antenna, but without stable attitude control, they could not hold it steady. As they were unaware of the computer failure, they continued sending commands to Ranger 3 in vain. Sporadic tracking of the probe continued until January 31 when the attitude control thrusters exhausted their propellant supply, at which point the mission was officially terminated.

Footnotes