In a radio receiver circuit, the RF front end is a generic term for all the circuitry between a receiver's antenna input up to and including the mixer stage. It consists of all the components in the receiver that process the signal at the original incoming radio frequency, before it is converted to a lower intermediate frequency. In microwave and satellite receivers it is often called the low-noise block or low-noise downconverter and is often located at the antenna, so that the signal from the antenna can be transferred to the rest of the receiver at the more easily handled intermediate frequency. For most superheterodyne architectures, the RF front end consists of:
An RF amplifier, often called the low-noise amplifier. Its primary responsibility is to increase the sensitivity of the receiver by amplifying weak signals without contaminating them with noise, so that they can stay above the noiselevel in succeeding stages. It must have a very low noise figure. The RF amplifier may not be needed and is often omitted for frequencies below 30 MHz, where the signal-to-noise ratio is defined by atmospheric and man-made noise.
The mixer, which mixes the incoming signal with the signal from the localoscillator to convert the signal to the intermediate frequency.
In digital receivers, particularly those in wireless devices such as cell phones and Wifi receivers, the intermediate frequency is digitized; sampled and converted to a binary digital form, and the rest of the processing – IF filtering and demodulation – is done by digital filters, as these are smaller, use less power and can have more selectivity. In this type of receiver the RF front end is defined as everything from the antenna to the analog-to-digital converter which digitizes the signal. The general trend is to do as much of the signal processing in digital form as possible, and some receivers digitize the RF signal directly, without down-conversion to an IF, so here the front end is merely an RF filter in the simple receiver path/chain. In the transmitter path RF front end consists typically a amplifier duplexer/diplexer and possibly a switch.
