In experimental particle physics, pseudorapidity,, is a commonly used spatial coordinate describing the angle of a particle relative to the beam axis. It is defined as where is the angle between the particle three-momentum and the positive direction of the beam axis. Inversely, As a function of three-momentum, pseudorapidity can be written as where is the component of the momentum along the beam axis. In the limit where the particle is travelling close to the speed of light, or equivalently in the approximation that the mass of the particle is negligible, one can make the substitution , and hence the pseudorapidity converges to the definition of rapidity used in experimental particle physics: This differs slightly from the definition of rapidity in special relativity, which uses instead of. However, pseudorapidity depends only on the polar angle of the particle's trajectory, and not on the energy of the particle. One speaks of the "forward" direction in a hadron collider experiment, which refers to regions of the detector that are close to the beam axis, at high ; in contexts where the distinction between "forward" and "backward" is relevant, the former refers to the positive z-direction and the latter to the negative z-direction. In hadron collider physics, the rapidity is preferred over the polar angle because, loosely speaking, particle production is constant as a function of rapidity, and because differences in rapidity are Lorentz invariant under boosts along the longitudinal axis: they transform additively, similar to velocities in Galilean relativity. A measurement of a rapidity difference between particles is hence not dependent on the longitudinal boost of the reference frame. This is an important feature for hadron collider physics, where the colliding partons carry different longitudinal momentum fractions x, which means that the rest frames of the parton-parton collisions will have different longitudinal boosts. The rapidity as a function of pseudorapidity is given by where is the transverse momentum. Using a second-order Maclaurin expansion of expressed in one can approximate rapidity by which makes it easy to see that for relativistic particles with, pseudorapidity becomes equal to rapidity. Rapidity is used to define a measure of angular separation between particles commonly used in particle physics, which is Lorentz invariant under a boost along the longitudinal direction. Often, the rapidity term in this expression is replaced by pseudorapidity, yielding a definition with purely angular quantities: , which is Lorentz invariant if the involved particles are massless. The difference in azimuthal angle,, is invariant under Lorentz boosts along the beam line because it is measured in a plane orthogonal to the beam line.
Values
Here are some representative values: Pseudorapidity is odd about degrees. In other words,.
Conversion to Cartesian momenta
Hadron colliders measure physical momenta in terms of transverse momentum, polar angle in the transverse plane and pseudorapidity. To obtain cartesian momenta , the following conversions are used: Therefore,.
