Physics of firearms


From the viewpoint of physics, a firearm, as for most weapons, is a system for delivering maximum destructive energy to the target with minimum delivery of energy on the shooter. The momentum delivered to the target, however, cannot be any more than that on the shooter. This is because the momentum imparted to the bullet is equal to that imparted to the gun-shooter system.

Firearm energy efficiency

From a thermodynamic point of view, a firearm is a special type of piston engine, or in general heat engine where the bullet has a function of a piston. The energy conversion efficiency of a firearm strongly depends on its construction, especially on its caliber and barrel length.
However, for illustration, here is the energy balance of a typical small firearm for.300 Hawk ammunition:
which is comparable with a typical piston engine.
Higher efficiency can be achieved in longer barrel firearms because they have better volume ratio. However, the efficiency gain is less than corresponding to the volume ratio, because the expansion is not truly adiabatic and burnt gas becomes cold faster because of exchange of heat with the barrel. Large firearms achieve smaller barrel-heating loss because they have better volume-to-surface ratio.
High barrel diameter is also helpful because lower barrel friction is induced by sealing compared to the accelerating force. The force is proportional to the square of the barrel diameter while sealing needs are proportional to the perimeter by the same pressure.

Force

Assuming the gun and shooter are at rest, the force on the bullet is equal to that on the gun-shooter. This is due to Newton's third law of motion. Consider a system where the gun and shooter have a combined mass and the bullet has a mass. When the gun is fired, the two systems move away from one another with new velocities and respectively. But the law of conservation of momentum states that the magnitudes of their momenta must be equal:
Since force equals the rate of change in momentum and the initial momenta are zero, the force on the bullet must therefore be the same as the force on the gun/shooter.
Gunshot victims frequently fall or collapse when shot; this is less a result of the momentum of the bullet pushing them over, but is primarily caused by physical damage or psychological effects, perhaps combined with being off balance. This is not the case if the victim is hit by heavier projectiles such as 20 mm cannon shell, where the momentum effects can be enormous; this is why very few such weapons can be fired without being mounted on a weapons platform or involve a recoilless system.
Example:
A.44 Remington Magnum with a jacketed bullet is fired at at a target. What velocity is imparted to the target ?
Let and stand for the mass and velocity of the bullet, the latter just before hitting the target, and let and stand for the mass and velocity of the target after being hit.
Conservation of momentum requires
Solving for the target's velocity gives
This example shows the target barely moves at all. That's not to say one couldn't stop a train by firing bullets at it, it's just completely impractical.

Velocity

From Eq. 1 we can write for the velocity of the gun/shooter: V = mv/M. This shows that despite the high velocity of the bullet, the small bullet-mass to shooter-mass ratio results in a low recoil velocity although the force and momentum are equal.

Kinetic energy

However, the smaller mass of the bullet, compared to that of the gun-shooter system, allows significantly more kinetic energy to be imparted to the bullet than to the shooter. The kinetic energy for the two systems are for the gun-shooter system and for the bullet. The energy imparted to the shooter can then be written as:
If we now write for the ratio of these energies we have:
The ratio of the kinetic energies is the same as the ratio of the masses. Since the mass of the bullet is much less than that of the shooter there is more kinetic energy transferred to the bullet than to the shooter. Once discharged from the weapon, the bullet's energy decays throughout its flight, until the remainder is dissipated by colliding with a target.

Transfer of energy

When the bullet strikes, its high velocity and small frontal cross-section means that it will exert large stresses in any object it hits. This usually results in it penetrating any soft object, such as flesh. The energy is then dissipated in the wound track formed by the passage of the bullet. See terminal ballistics for a fuller discussion of these effects.
Bulletproof vests work by dissipating the bullet's energy in another way; the vest's material, usually Aramid, works by presenting a series of material layers which catch the bullet and spread its imparted force over a larger area, hopefully bringing the round to a stop before it can penetrate into the body. While the vest can prevent a bullet from penetrating, the wearer will still be affected by the kinetic energy of the bullet, which can produce serious internal injuries.