Optical landing system
An optical landing system is used to give glidepath information to pilots in the terminal phase of landing on an aircraft carrier. From the beginning of aircraft landing on ships in the 1920s to the introduction of OLSs, pilots relied solely on their visual perception of the landing area and the aid of the Landing Signal Officer. LSOs used coloured flags, cloth paddles and lighted wands. The OLS was developed after World War II by the British and was deployed on U.S. Navy carriers from 1955. In its developed form, the OLS consists of a horizontal row of green lights, used as a reference, and a column of vertical lights. The vertical lights signal whether the aircraft is too high, too low, or at the correct altitude as the pilot descends the glide slope towards the carrier's deck. Other lights give various commands and can be used to require the pilot to abort the landing and "go around." The OLS remains under control of the LSO, who can also communicate with the pilot via radio.
Components
An optical landing system has several related components: the lights used to give visual cues to approaching aircraft, the light control system, and the mounting system.Lights
At least three sets of lights are used, regardless of the actual technology:- Datum lights – a horizontal row of green lamps used to give the pilot a reference against which he may judge his position relative to the glide slope.
- Ball – indicates the relative position of the aircraft with reference to glide slope. If the aircraft is high, the ball will be above the datum lights; if the aircraft is low, the ball will be similarly below the datum lights. The further the aircraft is from the glide slope, the further the ball will be above or below the datum lights. If the aircraft gets dangerously low, the ball appears red. If the aircraft gets too high, the ball appears to go off the top.
- Wave-off lights – red flashing lamps which, when lit, indicate that the pilot must add full power and go around – a mandatory command. When the wave-off lights are lit, all other lamps are extinguished. The wave-off lights are operated manually by the LSO.
- Cut lights – Green lamps used to signal different things based on where the approaching aircraft is in its approach. Early in a no-radio or "zip-lip" approach, Cut Lights are flashed for approximately 2–3 seconds to indicate that the aircraft is cleared to continue the approach. Subsequent flashes of the Cut Lights are used to prompt the pilot to add power. The longer the lights are left on, the more power should be added. Cut Lights are operated manually by the LSO.
- Emergency wave-off lights – Red lamps that have the identical function as Wave-Off Lights, but use an alternate power source. Not normally used.
Light controls
Light mounting
For shore-based Optical Landing Systems, the lights are typically mounted on a mobile unit that plugs into a power source. Once set up and calibrated, there are no moving parts to the unit. Shipboard units are much more complicated as they must be gyroscopically stabilized to compensate for ship movement. Additionally, shipboard units are mechanically moved to adjust the touchdown point of each aircraft. With this adjustment, the tailhook touchdown point can be precisely targeted based on the tailhook-to-pilot's eye distance for each aircraft type.Mirror landing aid
The first OLS was the mirror landing aid, one of several British inventions made after the Second World War revolutionising the design of aircraft carriers. The others were the steam catapult and the angled flight deck. The Mirror Landing Aid was invented by Nicholas Goodhart. It was tested on the carriers HMS Illustrious and HMS Indomitable before being introduced on British carriers in 1954 and on US carriers in 1955.The mirror landing aid was a gyroscopically-controlled concave mirror on the port side of the flight deck. On either side of the mirror was a line of green coloured "datum lights". A bright orange "source" light was shone into the mirror creating the "ball" which could be seen by the aviator who was about to land. The position of the ball compared to the datum lights indicated the aircraft's position in relation to the desired glidepath: if the ball was above the datum, the plane was high; below the datum, the plane was low; between the datum, the plane was on glidepath. The gyro stabilisation compensated for much of the movement of the flight deck due to the sea, giving a constant glidepath.
Initially, the device was thought able to allow the pilot to land without direction from the LSO. However, accident rates actually increased upon the system's initial introduction, so the current system of including the LSO was developed. This development, along with the others mentioned, contributed to the US carrier landing accident rate plummeting from 35 per 10,000 landings in 1954 to 7 per 10,000 landings in 1957.
The LSO, who is a specially qualified and experienced Navy pilot, provides additional input to the pilot via radios, advising of power requirements, position relative to glide path and centerline. The LSO can also use a combination of lights attached to the OLS to indicate "go around" using the bright red, flashing wave off lights. Additional signals, such as "cleared to land", "add power", or "divert" can be signaled using with a row of green "cut" lights or a combination thereof.
Fresnel lens optical landing system (FLOLS)
Later systems kept the same basic function of the mirror landing aid, but upgraded components and functionality. The concave mirror, source light combination was replaced with a series of fresnel lenses. The Mk 6 Mod 3 FLOLS was tested in 1970 and had not changed much, except for when ship’s heave was taken into account with an Inertial Stabilization system. These systems are still in wide use on runways at US Naval Air Stations.Improved fresnel lens optical landing system (IFLOLS)
The IFLOLS, designed by engineers at NAEC Lakehurst, NJ, keeps the same basic design but improves on the FLOLS, giving a more precise indication of aircraft position on the glideslope. A prototype IFLOLS was tested on board USS George Washington in 1997 and every deploying aircraft carrier since 2004 has had the system. The Improved Fresnel Lens Optical Landing System, IFLOLS, uses a fiber optic "source" light, projected through lenses to present a sharper, crisper light. This has enabled pilots to begin to fly "the ball" further away from the ship making the transition from instrument flight to visual flight smoother. Additional improvements include better deck motion compensation due to internalization of the stabilizing mechanisms, as well as multiple sources of stabilization from gyroscopes as well as radar.Manually Operated Visual Landing Aid System (MOVLAS)
The MOVLAS is a backup visual landing aid system used when the primary optical system is inoperable, stabilization limits are exceeded or unreliable, and for pilot/LSO training. The system is designed to present glideslope information in the same visual form presented by the FLOLS.There are three installation modes aboard ship: STATION 1 is immediately in front of the FLOLS and utilizes the FLOLS waveoff, datum, and cut light displays. STATION 2 and 3 are independent of the FLOLS and are located on the flight deck port and starboard side respectively. MOVLAS is nothing more than a vertical series of orange lamps manually controlled by the LSO with a hand controller to simulate the ball; it does not automatically compensate for the ship's movement in any way. All MOVLAS equipment is maintained and rigged by the IC's and EM's within V2 Division of Air Department.
MOVLAS components
;Lightbox;Hand Controller
;Repeaters