Naval Aircraft Factory TS


The Naval Aircraft Factory TS-1 was an early biplane fighter aircraft of the United States Navy, serving from 1922 to 1929.

Development

While the Vought VE-7s were serving the Navy well in the early 1920s, they were not originally designed as fighters. The Naval Aircraft Factory came up with a simple design driven by a Lawrance J-1 air-cooled radial engine. Its boxy fuselage was suspended between the upper and lower wings, with the center area of the lower wing enlarged to accommodate a fuel tank.
The NAF provided Curtiss with the plans to build the aircraft, and the result, designated TS-1, arrived at Anacostia on May 9, 1922. The TS-1 from Curtiss was delivered with wheels, so the NAF also designed wooden floats to enable their use on vessels other than aircraft carriers. Testing went well, and in late 1922 the Navy ordered 34 planes from Curtiss, with the first arriving on board the aircraft carrier in December. The NAF built another five themselves, as a test of relative costs, as well as four more used to experiment with water-cooled inline engines.
Two all-metal versions of the aircraft, F4C-1s, were developed by Curtiss. This aircraft made its first flight on September 4, 1924. The wings had tubular spars and stamped duraluminum ribs, the fuselage was constructed of duraluminum tubing in a Warren truss form. Compared to the TS-1, the lower wing was raised to the base of the fuselage. The F4C-1 was armed with two machine guns and was powered by a 200 hp nine-cylinder Wright J-3 radial.

Operational history

In addition to operating from the carrier deck, the TS-1s served for several years in floatplane configuration aboard destroyers, cruisers, and battleships. The aircraft were slung over the side by crane. Squadron VO-1 operated this way from 1922, and VF-1 flew its float-equipped TS-1s from battleships in 1925 and 1926.
The TS-1 was not universally liked by its crews. Positioning of the lower wing below the fuselage resulted in short wheel struts. This, and the wheels' placement close to each other, caused considerable problems with ground looping.

Variants

;NAF TS-1: five built
;Curtiss TS-1: 34 built
;NAF TS-2: two built, Aeromarine engine
;NAF TS-3: two built, Wright-Hispano E engine
;NAF TR-2: one built, TS-3 modified by changing the airfoil section on the wings for the 1922 Curtiss Marine Trophy race
;Curtiss-Hall F4C-1:All metal versions for comparison to the original wood and wire construction ; two built.

Operators

;