The maximum segment size is a parameter of the options field of the TCP header that specifies the largest amount of data, specified in bytes, that a computer or communications device can receive in a single TCP segment. It does not count the TCP header or the IP header. The IP datagram containing a TCP segment may be self-contained within a single packet, or it may be reconstructed from several fragmented pieces; either way, the MSS limit applies to the total amount of data contained in the final, reconstructed TCP segment. To avoid fragmentation in the IP layer, a host must specify the maximum segment size as equal to the largest IP datagram that the host can handle minus the IP and TCP header sizes. Therefore, IPv4 hosts are required to be able to handle an MSS of 536 octets and IPv6 hosts are required to be able to handle an MSS of 1220 octets. Small MSS values will reduce or eliminate IP fragmentation but will result in higher overhead. Each direction of data flow can use a different MSS. For most computer users, the MSS option is established by the operating system.
Default value
The default TCP Maximum Segment Size is 536. Where a host wishes to set the maximum segment size to a value other than the default, the maximum segment size is specified as a TCP option, initially in the TCP SYN packet during the TCP handshake. The value cannot be changed after the connection is established.
Inter-Layer Communication
In order to notify MSS to the other end, an inter-layer communication is done as follows:
The IP should ask the Network Driver for the Maximum Transmission Unit.
The TCP should ask the IP for the Maximum Datagram Data Size. This is the MTU minus the IP header length.
When opening a connection, TCP can send an MSS option with the value equal to: MDDS - TCPHdrLen. In other words, the MSS value to send is: MSS = MTU - TCPHdrLen - IPHdrLen
While sending TCP segments to the other end, an inter-layer communication is done as follows:
TCP should determine the Maximum Segment Data Size from either the default or the received value of the MSS option.
TCP should determine if source fragmentation is possible and desirable.
* If so, TCP may hand to IP, segments up to MSDS + TCPHdrLen.
* If not, TCP may hand to IP, segments up to the lesser of and MDDS.
IP checksthe length of data passed to it by TCP. If the length is less than or equal MDDS, IP attaches the IP header and hands it to the ND. Otherwise, the IP must do source fragmentation.
MSS and MTU
MSS is sometimes conflated with MTU/PMTU, which is a characteristic of the underlying link layer, while MSS applies specifically to TCP and hence the transport layer. The two are similar in that they limit the maximum size of the payload carried by their respective protocol data unit, and related since MSS cannot exceed the MTU for its underlying link. However, the difference, in addition to applying to different layers, is that MSS can have a different value in either direction and also that frames exceeding the MTU may end up getting fragmented by the transport layer, while segments exceeding the MSS are simply discarded.
