MPLSFast Reroute is a local restoration network resiliency mechanism. It is actually a feature of resource reservation protocoltraffic engineering. In MPLS local protection each label switched path passing through a facility is protected by a backup path which originates at the node immediately upstream to that facility. This node which redirects the traffic onto the preset backup path is called the Point of Local Repair , and the node where a backup LSP merges with the primary LSP is called Merge Point . This mechanism provides faster recovery because the decision of recovery is strictly local. For comparison, when recovery mechanisms are employed at the IP layer, restoration may take several seconds which is unacceptable for real-time applications. In contrast, MPLS local protection meets the requirements of real-time applications with recovery times comparable to those of shortest path bridging networks or SONET rings.
Local protection approaches
There are two distinct approaches to local protection: one-to-one local protection many-to-one local protection.
One-to-one local protection
In one-to-one backup approach, the PLRs maintain separate backup paths for each LSP passing through a facility. The backup path terminates by merging back with the primary path at a node called the Merge Point. In one-to-one backup approach, the MP can be any node downstream from the protected facility. Maintaining state information for backup paths protecting individual LSPs, as in the one-to-one approach, is a significant resource burden for the PLR. Moreover, periodic refresh messages sent by the PLR, in order to maintain each backup path, may become a network bottleneck.
Many-to-one local protection
In many-to-one approach, a PLR maintains a single backup path to protect a set of primary LSPs traversing the triplet. Thus, fewer states need to be maintained and refreshed which results in a scalable solution. The many-to-one backup approach is also called facility backup. Note that in this approach, the MP should be the node immediately downstream to the facility.
Example
In Fig.1, there is a primary path from A to E via B and D. The traffic of customers connected to A and E will take this path in normal operation. There is also a secondary path from A to E via C. This path can be either pre-signaled or not. For the primary LSP, FRR is enabled. Once enabled, the other network elements on the LSP will know that FRR is enabled. Let's assume there is a break between D and E. D will immediately know this and will inform B and A. For A to know that there is a failure between D and E takesa while, but since D knows about the failure immediately and FRR is enabled on the LSP, it uses the detour path D-C-E to get rid of the failure immediately and traffic will continue to flow along that new path. This takes less than 50ms. Once the secondary LSP is up, traffic is switched to the secondary LSP and the temporary detour path is disabled.
