Hillman Super Minx
The Hillman Super Minx is a family car which was produced by Hillman from 1961 to 1967. It was a slightly larger version of the Hillman Minx, from the period when the long-running Minx nameplate was applied to the "Audax" series of designs.
Announced in October 1961, the Super Minx gave Rootes, and particularly its Hillman marque, an expanded presence in the upper reaches of the family car market. It has been suggested that the Super Minx design was originally intended to replace, and not merely to supplement, the standard Minx, but was found to be too big for that purpose. An estate car joined the range in May 1962, and a two-door convertible in June 1962. The convertible never sold in significant numbers: the last one was made in June 1964, ahead of the introduction, in September 1964, of the Super Minx Mark III.
The car was powered by the Rootes unit, which had first appeared late in 1953 with a capacity. The original Super Minx had the cast-iron cylinder head version of the engine, though on later cars the cylinder head was replaced with an aluminium one.
Suspension was independent at the front using coil springs with anti-roll bar and at the rear had leaf springs and a live axle. Un-assisted Lockheed drum brakes were fitted. The steering used a recirculating ball system and was as usual at the time not power assisted. Standard seating, trimmed in Vynide, used a bench type at the front with individual seats as an option. A heater was fitted but a radio remained optional. The car could be ordered in single colour or two tone paint. The four-speed manual transmission featured synchromesh on the top three ratios from the start and had a floor lever: "Smiths Easidrive" automatic transmission was option.
A car was tested by the British magazine The Motor in 1962 and had a top speed of and could accelerate from 0- in 21.6 seconds. A "touring" fuel consumption of was recorded. The test car cost £854 including taxes, which was then slightly less than the recently upgraded Austin Cambridge A60.
The first Super Minxes featured the engine as used in the Hillman Minx, providing in this application a claimed of power.
Mark II
A year after the car was launched a Mark II version was presented, in October 1962, with greasing points eliminated, larger front disc brakes and a revised axle ratio. For buyers of the automatic transmission cars, 1962 was the year that the Smiths Easidrive option was replaced by the Borg-Warner 35 transmission.Mark III
In 1964, with the launch of the Super Minx Mark III the Super Minx was facelifted, and the wrap-around rear window gave way to a new "six-light" design with a larger side windows aft of the rear side doors. The windscreen and side windows were also made taller and the roof-line flatter.Mark IV
Engine capacity was increased to for the Super Minx Mark IV launched at the London Motor Show in October 1965.Related models
Like many other Rootes products including the Minx, the Super Minx was one of a badge-engineered series of models, sold under various marques.The Singer marque was represented by the Singer Vogue which had been announced in July 1961, four months earlier than the Hillman Super Minx. The range was joined in 1963 by a Humber: the Humber Sceptre. The Singer Vogue and Humber Sceptre names would be retained by the successor Rootes Arrow model range. The Sceptre was developed as a four-door replacement for the Sunbeam Rapier, but was re-designated as a Humber shortly before launch, while the two-door Rapier based on the 'Audax' Minx continued unreplaced until 1967. The Sceptre nevertheless was able to be successfully promoted as a more sporty car than the larger traditional Humbers. Unlike the Hillman and Singer versions, the Super Minx based Humber Sceptre retained the same roof, with large panoramic windscreen and shallow wrap-around rear window with fins, until the model was replaced, in the Humber's case in 1967, by a Hillman Hunter based successor.
The cars differed in subtle ways, with the Singer being positioned slightly above the Hillman and gaining such extras as quad headlights, and the Humber topping the range, commensurate with Humber's traditional role as a producer of upmarket and luxury models. The styling of the Sceptre somewhat recalled previous, larger Humbers. The Sceptre marks 1 and 1A had a slightly different grille arrangement and front trim to the Vogue as well as a taller panoramic windscreen, sloping rear roofline and larger rear fins.. It had been intended that the Sceptre be a sports saloon until shortly before its launch as a Humber, hence its sprightly performance compared with other Humber models.
Nearly five years after its launch, a Singer Vogue Series IV saloon tested by the Britain’s Autocar magazine in August 1966, now with an advertised power output of, had a top speed of and could accelerate from 0- in 25 seconds. An overall fuel consumption of was achieved. The test car was priced by Rootes in the UK at £911 including taxes, at a time when the Austin 1800 was retailing for £888 and the Ford Corsair GT was offered at £925. The performance was felt to be lively, and the gear change, supported on the test car with an optional overdrive, ‘crisp’ with well chosen ratios. Comfort and fittings were also commended, but the fuel consumption and the tendency of the heavy brakes to fade when used hard disappointed the testers: this would presumably not have been an issue had the road test been of a Humber Sceptre which had its stopping power from a servo-assisted front disc/rear drum arrangement.
The Humber was also, at launch, fitted with a high tune version of the 1,592 cc and, from September 1965, 1,725 cc oversquare engine producing and respectively. Early models with the 1,592 cc engine had twin single Zenith downdraught carburettors - later 1,592/1,725 cc engines used a Solex twin choke downdraught carburettor for simplicity. The twin Zenith carburettors had been hard to keep balanced. Other modifications included a water-jacketed inlet manifold, timing adjustments and stronger valve springs to eliminate valve bounce at high engine speeds. The later H120's engine is a straight swap for both of these units and looks almost identical - it provides a useful boost in power to an already swift automobile. The unique Sceptre interior featured full instrumentation, including a tachometer marked up to 6,000 rpm, and a four-speed floor-mounted transmission with self-cancelling overdrive on third and fourth gear for a total of six separate ratios in standard form. The lockout could be removed on first and second gears, and this was often done by Rootes in cars used for competitions such as rallying. In addition, the Sceptre was from the beginning provided with servo-assisted braking control and, unusually in 1963, 10-inch front disc-brakes. The Marks 1 and 1A were not available with an automatic option - although this was rectified with the Mark II cars, using a three-speed unit with automatic kick-down. This was a cheaper option than was usual at the time due to the deletion of the Laycock De Normanville overdrive fitted to the Manual cars.
There was a Singer variant of the smaller Minx as well but no equivalent Humber version of the Minx, which would have been uncharacteristically small for the Humber marque; conversely there was a sporty Sunbeam version of the Minx but no Sunbeam version of the Super Minx.
In addition to assembling the Super Minx, Rootes Australia produced variants of the Singer Vogue from 1963 to 1966 as the Humber Vogue and Humber Vogue Sports.
At least six Humber Sceptre development mules were built with the same engine as the Sunbeam Tiger, a 289 cui Ford V8 unit. These never entered production, but at least one of the original cars survives.