Geometric phase


In classical and quantum mechanics, the geometric phase is a phase difference acquired over the course of a cycle, when a system is subjected to cyclic adiabatic processes, which results from the geometrical properties of the parameter space of the Hamiltonian. The phenomenon was independently discovered by S. Pancharatnam and by H. C. Longuet-Higgins and later generalized by Sir M. Berry.
It is also known as the Pancharatnam–Berry phase, Pancharatnam phase, or Berry phase.
It can be seen in the Aharonov–Bohm effect and in the conical intersection of potential energy surfaces.
In the case of the Aharonov–Bohm effect, the adiabatic parameter is the magnetic field enclosed by two interference paths, and it is cyclic in the sense that these two paths form a loop. In the case of the conical intersection, the adiabatic parameters are the molecular coordinates. Apart from quantum mechanics, it arises in a variety of other wave systems, such as classical optics. As a rule of thumb, it can occur whenever there are at least two parameters characterizing a wave in the vicinity of some sort of singularity or hole in the topology; two parameters are required because either the set of nonsingular states will not be simply connected, or there will be nonzero holonomy.
Waves are characterized by amplitude and phase, and may vary as a function of those parameters. The geometric phase occurs when both parameters are changed simultaneously but very slowly, and eventually brought back to the initial configuration. In quantum mechanics, this could involve rotations but also translations of particles, which are apparently undone at the end. One might expect that the waves in the system return to the initial state, as characterized by the amplitudes and phases. However, if the parameter excursions correspond to a loop instead of a self-retracing back-and-forth variation, then it is possible that the initial and final states differ in their phases. This phase difference is the geometric phase, and its occurrence typically indicates that the system's parameter dependence is singular for some combination of parameters.
To measure the geometric phase in a wave system, an interference experiment is required. The Foucault pendulum is an example from classical mechanics that is sometimes used to illustrate the geometric phase. This mechanics analogue of the geometric phase is known as the Hannay angle.

Berry phase in quantum mechanics

In a quantum system at the n-th eigenstate, an adiabatic evolution of the Hamiltonian sees the system remain in the n-th eigenstate of the Hamiltonian, while also obtaining a phase factor. The phase obtained has a contribution from the state's time evolution and another from the variation of the eigenstate with the changing Hamiltonian. The second term corresponds to the Berry phase and for non-cyclical variations of the Hamiltonian it can be made to vanish by a different choice of the phase associated with the eigenstates of the Hamiltonian at each point in the evolution.
However, if the variation is cyclical, the Berry phase cannot be cancelled; it is invariant and becomes an observable property of the system. By reviewing the proof of the adiabatic theorem given by Max Born and Vladimir Fock, in Zeitschrift für Physik 51, 165, we could characterize the whole change of the adiabatic process into a phase term. Under the adiabatic approximation, the coefficient of the nth eigenstate under adiabatic process is given by
where is the Berry's phase with respect of parameter t. Changing the variable t into generalized parameters, we could rewrite the Berry's phase into
where parametrizes the cyclic adiabatic process. It follows a closed path in the appropriate parameter space. Geometric phase along the closed path can also be calculated by integrating the Berry curvature over surface enclosed by.

Examples of geometric phases

The Foucault pendulum

One of the easiest examples is the Foucault pendulum. An easy explanation in terms of geometric phases is given by Wilczek and Shapere
To put it in different words, there are no inertial forces that could make the pendulum precess, so the precession is entirely due to the turning of this path. Thus the orientation of the pendulum undergoes parallel transport. For the original Foucault pendulum, the path is a circle of latitude, and by the Gauss–Bonnet theorem, the phase shift is given by the enclosed solid angle.

Polarized light in an optical fiber

A second example is linearly polarized light entering a single-mode optical fiber. Suppose the fiber traces out some path in space and the light exits the fiber in the same direction as it entered. Then compare the initial and final polarizations. In semiclassical approximation the fiber functions as a waveguide and the momentum of the light is at all times tangent to the fiber. The polarization can be thought of as an orientation perpendicular to the momentum. As the fiber traces out its path, the momentum vector of the light traces out a path on the sphere in momentum space. The path is closed since initial and final directions of the light coincide, and the polarization is a vector tangent to the sphere. Going to momentum space is equivalent to taking the Gauss map. There are no forces that could make the polarization turn, just the constraint to remain tangent to the sphere. Thus the polarization undergoes parallel transport and the phase shift is given by the enclosed solid angle.

Stochastic pump effect

A stochastic pump is a classical stochastic system that responds with nonzero, on average, currents to periodic changes of parameters.
The stochastic pump effect can be interpreted in terms of a geometric phase in evolution of the moment generating function of stochastic currents.

Spin ½

The geometric phase can be evaluated exactly for a spin-½ particle in a magnetic field.

Geometric phase defined on attractors

While Berry's formulation was originally defined for linear Hamiltonian systems, it was soon realized by Ning and Haken
that similar geometric phase can be defined for entirely different systems such as nonlinear dissipative systems that possess certain cyclic attractors. They showed that such cyclic attractors exist in a class of nonlinear dissipative systems with certain symmetries.

Exposure in molecular adiabatic potential surface intersections

There are several ways to compute the geometric phase in molecules within the Born Oppenheimer framework. One way is through the "non-adiabatic coupling matrix" defined by
where is the adiabatic electronic wave function, depending on the nuclear parameters. The nonadiabatic coupling can be used to define a loop integral, analogous to a Wilson loop in field theory, developed independently for molecular framework by M. Baer. Given a closed loop, parameterized by where is a parameter and. The D-matrix is given by:
. It can be shown that once is large enough this matrix is diagonal with the diagonal elements equal to where are the geometric phases associated with the loop for the adiabatic electronic state.
For time-reversal symmetrical electronic Hamiltonians the geometric phase reflects the number of conical intersections encircled by the loop. More accurately:
where is the number of conical intersections involving the adiabatic state encircled by the loop.
An alternative to the D-matrix approach would be a direct calculation of the Pancharatnam phase. This is especially useful if one is interested only in the geometric phases of a single adiabatic state. In this approach, one takes a number of points along the loop with and then using only the jth adiabatic states computes the Pancharatnam product of overlaps:
In the limit one has :

Geometric phase and quantization of cyclotron motion

An electron subjected to magnetic field moves on a circular orbit. Classically, any cyclotron radius is acceptable. Quantum-mechanically, only discrete energy levels are allowed and since is related to electron's energy, this corresponds to quantized values of. The energy quantization condition obtained by solving Schrödinger's equation reads, for example, for free electrons or for electrons in graphene where. Although the derivation of these results is not difficult, there is an alternative way of deriving them which offers in some respect better physical insight into the Landau level quantization. This alternative way is based on the semiclassical Bohr-Sommerfeld quantization condition
which includes the geometric phase picked up by the electron while it executes its motion along the closed loop of the cyclotron orbit. For free electrons, while for electrons in graphene. It turns out that the geometric phase is directly linked to of free electrons and of electrons in graphene.

Footnotes