Floptical refers to a type of floppy disk drive that combines magnetic and optical technologies to store data on media similar to standard -inch floppy disks. The name is a portmanteau of the words "floppy" and "optical". It refers specifically to one brand of drive and disk system, but is also used more generically to refer to any system using similar techniques. The original Floptical technology was announced in 1988 and introduced late in 1991 by Insite Peripherals, a venture funded company set up by Jim Adkisson, one of the key engineers behind the original -inch floppy disk drive development at Shugart Associates in 1976. The main shareholders were Maxell, Iomega and 3M.
Technical aspects
The technology involves reading and writing data magnetically, while optically aligning the read/write head in the drive using grooves in the disk being sensed by an infrared LED and sensor. The magnetic head touches the recording surface, as it does in a normal floppy drive. The optical servo tracks allow for an increase in the tracking precision of the magnetic head, from the usual 135 tracks per inch to tracks per inch. Floptical disks provide 21 MB of storage. The drive has a second set of read/write heads so that it can read from and write to standard 720 kB and 1.44 MB disks as well. To allow for a high degree of compatibility with existing SCSI host adapters, Floptical drives were designed to work as a standard floppy disk drive, and not as a removable hard disk. To ensure this, a "write lockout" feature was added in the firmware. This effectively inhibits writing of the media. It is possible to unlock the drive by issuing a SCSI Mode Sense Command,. It is unclear how much of a problem this is, and Insite also issued EPROMs where this "feature" was not present. At least two models were produced, one with a manual lever that mechanically ejected the disc from the drive, and another with a small pinhole into which a paperclip can be inserted, in case the device rejected or ignored SCSI eject commands.
Market performance
Insite licensed the floptical technology to a number of companies, including Matsushita, Iomega, Maxell/Hitachi and others. A number of these companies later formed the Floptical Technology Association, or FTA, to try to have the format adopted as a replacement of standard floppy disks. Around Insite Flopticals are believed to have been sold worldwide in the product's lifetime. Silicon Graphics used them in their SGI Indigo and SGI Indy series of computer workstations. It was also reported that Commodore International had selected the Insite Floptical for its Amiga 3000. However, this did not take place, and while Flopticals were installed in many Amiga systems, they were sold by either Insite, TTR Development or Digital Micronics, and not bundled by Commodore. Iomega licensed the Floptical technology as early as 1989 and produced a compatible drive known as the Insider. A few years later, a number of other companies introduced Floptical-like but incompatible systems: Iomega introduced their own ZIP-100 system storing 100 MB in 1994, which would go on to sell into the tens of millions. Later versions would increase the capacity to 250 and 750 MB. Another similar system was Imation's LS‑120SuperDisk in 1996. The LS-120 stored 120 MB of data while retaining the ability to work with normal -inch disks, interfacing as a standard floppy for better compatibility. A later LS-240 version would store up to 240 MB. A smaller competitor was the almost unknown Caleb UHD144 in 1997. Since 1998 Sony also tried their own Floptical-based format, the Sony HiFD, but quality control problems ruined its reputation. The first version could store 150 MB, but it was soon replaced by a 200 MB version. There was serious consideration that one of these systems would succeed where the Floptical failed and replace the standard floppy disk outright, but the rapid introduction of writable CD-ROM systems in the early 2000s made the market disappear.
