The Urban Dynamometer Driving Schedule is a mandated dynamometer test on tailpipe emissions of a car that represents city driving conditions. It is defined in. It is also known as FTP-72 or LA-4, and it is also used in Sweden as the A10 or CVS cycle and in Australia as the ADR 27 cycle. The cycle simulates an urban route of 12.07 km with frequent stops. The maximum speed is 91.2 km/h and the average speed is 31.5 km/h. The cycle has two phases: a "cold start" phase of 505 seconds over a projected distance of 5.78 km at 41.2 km/h average speed, and a "transient phase" of 864 seconds, for a total duration of 1369 seconds.
FTP-75
The "city" driving program of the EPA Federal Test Procedure is identical to the UDDS plus the first 505 seconds of an additional UDDS cycle. FTP-75 driving cycle Then the characteristics of the cycle are:
Distance travelled: 17.77 km
Duration: 1874 seconds
Average speed: 34.1 km/h
The procedure is updated by adding the "hot start" cycle that repeats the "cold start" cycle of the beginning of the UDDS cycle. The average speed is thus different but the maximum speed remains the same as in the UDDS. The weighting factors are 0.43 for the cold start and transient phases together and 0.57 for the hot start phase. Though it was originally created as a reference point for fossil fuelled vehicles, the UDDS and thus the FTP-75, are also used to estimate the range in distance travelled by an electric vehicle in a single charge.
Deceptions
It is alleged that, similarly than in the NEDC, some automakers overinflate tyres, adjusting or disconnecting brakes to reduce friction, and taping cracks between body panels and windows to reduce air resistance, some go as far as removing wing mirrors, to inflate measured fuel economy and lower measured carbon emission. In addition, it has been brought to attention that the relative height of the simulated wind fan with respect to the vehicle could alter the performance of aftertreatment systems due to changes in temperature and, consequently, modify the pollutant emissions values.
Highway driving
The "highway" program or Highway Fuel Economy Driving Schedule is defined in. It uses a warmed-up engine and makes no stops, averaging 48 mph with a top speed of 60 mph over a distance. The following are some characteristic parameters of the cycle:
Duration: 765 seconds
Total distance: 10.26 miles
Average Speed: 48.3 mi/h
The measurements are adjusted downward by 10% and 22% to more accurately reflect real-world results.
Supplemental tests
In 2007, the EPA added three new Supplemental Federal Test Procedure tests that combine the current city and highway cycles to reflect real world fuel economy more accurately,. Estimates are available for vehicles back to the 1985 model year.
US06
The US06 Supplemental Federal Test Procedure was developed to address the shortcomings with the FTP-75 test cycle in the representation of aggressive, high speed and/or high acceleration driving behavior, rapid speed fluctuations, and driving behavior following startup. SFTP US06 is a high speed/quick acceleration loop that lasts 10 minutes, covers, averages and reaches a top speed of. Four stops are included, and brisk acceleration maximizes at a rate of per second. The engine begins warm and air conditioning is not used. Ambient temperature varies between to. The cycle represents an 8.01 mile route with an average speed of 48.4 miles/h, maximum speed 80.3 miles/h, and a duration of 596 seconds.
SC03
The SC03 Supplemental Federal Test Procedure has been introduced to represent the engine load and emissions associated with the use of air conditioning units in vehicles certified over the FTP-75 test cycle. SFTO SC03 is the air conditioning test, which raises ambient temperatures to, and puts the vehicle's climate control system to use. Lasting 9.9 minutes, the loop averages and maximizes at a rate of. Five stops are included, idling occurs 19 percent of the time and acceleration of 5.1 mph/sec is achieved. Engine temperatures begin warm. The cycle represents a 3.6 mile route with an average speed of 21.6 miles/h, maximum speed 54.8 miles/h, and a duration of 596 seconds.
Cold cycle
A cold temperature cycle uses the same parameters as the current city loop, except that ambient temperature is set to.
EPA tests for fuel economy do not include electrical load tests beyond climate control, which may account for some of the discrepancy between EPA and real world fuel-efficiency. A 200 W electrical load can produce a 0.4 km/L reduction in efficiency on the FTP 75 cycle test.
