Electromagnetic reverberation chamber


An electromagnetic reverberation chamber or mode-stirred chamber is an environment for electromagnetic compatibility testing and other electromagnetic investigations. Electromagnetic reverberation chambers have been introduced first by H.A. Mendes in 1968. A reverberation chamber is screened room with a minimum of absorption of electromagnetic energy. Due to the low absorption very high field strength can be achieved with moderate input power. A reverberation chamber is a cavity resonator with a high Q factor. Thus, the spatial distribution of the electrical and magnetic field strengths is strongly inhomogeneous. To reduce this inhomogeneity, one or more tuners are used. A tuner is a construction with large metallic reflectors that can be moved to different orientations in order to achieve different boundary conditions. The Lowest Usable Frequency of a reverberation chamber depends on the size of the chamber and the design of the tuner. Small chambers have a higher LUF than large chambers.
The concept of a reverberation chambers is comparable to a microwave oven.

Glossary/notation

Preface

The notation is mainly the same as in the IEC standard 61000-4-21. For statistic quantities like mean and maximal values, a more explicit notation is used in order to emphasize the used domain. Here, spatial domain means that quantities are taken for different chamber positions, and ensemble domain refers to different boundary or excitation conditions.

General

Cavity resonator

A reverberation chamber is cavity resonator—usually a screened room—that is operated in the overmoded region. To understand what that means we have to investigate cavity resonators briefly.
For rectangular cavities, the resonance frequencies are given by
where is the speed of light,, and are the cavity's length, width and height, and,, are non-negative integers.
With that equation, the number of modes with an eigenfrequency less than a given limit,, can be counted. This results in a stepwise function. In principle, two modes—a transversal electric mode and a transversal magnetic mode —exist for each eigenfrequency.
The fields at the chamber position are given by











Due to the boundary conditions for the E- and H field, some modes do not exist. The restrictions are:
A smooth approximation of,, is given by
The leading term is proportional to the chamber volume and to the third power of the frequency. This term is identical to Weyl's formula.
Based on the mode density is given by
An important quantity is the number of modes in a certain frequency interval,, that is given by

Quality factor

The Quality Factor is an important quantity for all resonant systems. Generally, the Q factor is defined by
where the maximum and the average are taken over one cycle, and is the angular frequency.
The factor Q of the TE and TM modes can be calculated from the fields. The stored energy is given by
The loss occurs in the metallic walls. If the wall's electrical conductivity is and its permeability is, the surface resistance is
where is the skin depth of the wall material.
The losses are calculated according to
For a rectangular cavity follows

Using the Q values of the individual modes, an averaged Composite Quality Factor can be derived:
includes only losses due to the finite conductivity of the chamber walls and is therefore an upper limit. Other losses are dielectric losses e.g. in antenna support structures, losses due to wall coatings, and leakage losses. For the lower frequency range the dominant loss is due to the antenna used to couple energy to the room and to monitor the fields in the chamber. This antenna loss is given by
where is the number of antenna in the chamber.
The quality factor including all losses is the harmonic sum of the factors for all single loss processes:
Resulting from the finite quality factor the eigenmodes are broaden in frequency, i.e. a mode can be excited even if the operating frequency does not exactly match the eigenfrequency. Therefore, more eigenmodes are exited for a given frequency at the same time.
The Q-bandwidth is a measure of the frequency bandwidth over which the modes in a reverberation chamber are
correlated. The of a reverberation chamber can be calculated using the following:
Using the formula the number of modes excited within results to
Related to the chamber quality factor is the chamber time constant by
That is the time constant of the free energy relaxation of the chamber's field if the input power is switched off.