The Colt-Burgess rifle is similar in design to Winchester's lever-action rifles, such as the Winchester Model 1873. It was produced in two versions chambered for the.44-40 Winchester cartridge: a rifle version with a barrel, and a carbine with a barrel. The rifle features either a full octagon, half-octagon, or round barrel, with the full octagon barrels being the most numerously produced among rifle variants. A tubular magazine is located under the barrel in similar fashion to other lever-action rifles with a capacity of 15 rounds in the rifle version or 12 rounds in the carbine version. The receiver on the Burgess rifle is smaller than the Winchester 1873's, providing for a lighter firearm. The rifle's action, though similar to the Winchester 1873's, is considered to be a stronger design. The action utilizes a toggle-joint system to lock the breechblock. The extension of the loading lever is the lower part of the toggle-joint; the upper part of the toggle-joint is linked to the breechblock. Located on the receiver is a sliding loading gate from which cartridges are fed into the magazine; the sliding gate design is in contrast to Winchester's tilting gate. Burgess rifles were finished with either a blued or browned barrel, blued receiver, casehardened hammer and lever, and walnut stock. Current reproduction Burgess rifles are also available with casehardened frames.
Production
Although Colt predominately was a manufacturer of popular revolvers, such as the Colt Single Action Army, the company began in the 1880s to seek to compete against Winchester in the rifle market. In 1882, Colt contacted Andrew Burgess to design a lever-action rifle and by July 1883, production of the new rifle had begun. The Colt-Burgess was produced for sixteen months thereafter, with a total of 6,403 guns manufactured. Approximately 60% of these were of the rifle variation. When compared to production figures of Winchester's 1873 rifle, the Colt-Burgess failed as a serious competitor to Winchester. From 1873 to 1919, Winchester manufactured 720,610 Model 1873 rifles, or an average of over 15,000 per year. The short production history of the Colt-Burgess has led to much speculation as to the reason of its demise. According to legend, upon hearing of Colt's entrance into the lever-action rifle market, Winchester began to develop a prototyperevolver to compete with Colt's market. A "gentleman's agreement" then followed between Colt and Winchester, with Colt agreeing to drop production of the Burgess and Winchester abandoning its plans to develop a revolver. The truth of this story has never been fully verified, and as such, the reason for the Burgess rifle's short production history is unknown. Replicas of the Burgess rifle and carbine are currently produced by the Italian manufacturer Uberti chambered for the.45 Colt cartridge.
