Army Combat Uniform
The Army Combat Uniform is the current combat uniform worn by the United States Army, U.S. Air Force, and United States Space Force.
First unveiled in June 2004, it is the successor to the Battle Dress Uniform and Desert Camouflage Uniform worn from the 1980s and 1990s through to the mid-2000s, respectively. It is also the successor to the Airman Battle Uniform for the U.S. Air Force.
History
Development
In early 2004, some U.S. Army soldiers in Iraq were issued the "Close Combat Uniform" a variant of the Desert Camouflage Uniform that featured new features such as shoulder pockets affixed with hook-and-loop "Velcro" fasteners, chest-worn rank insignia, and a new collar. The experimental features used on the CCU were eventually incorporated into the ACU, which was publicly announced in June 2004.Initial fielding
The process of replacing the U.S. Army's BDUs and DCUs with the ACU was to set to begin in April 2005. However, the fielding process began two months earlier through the Rapid Fielding Initiative. Soldiers from the 48th Infantry Brigade Combat Team were the first in the U.S. Army to receive the ACU, subsequently deploying with them into Iraq in May 2005.Universal Camouflage Pattern (UCP)
The ACU originally used the Universal Camouflage Pattern, which used a pixelated pattern of tan, gray and green and was intended to work in desert, woodland, and urban environments. For uniforms, the pattern was fully phased out and replaced by the Operational Camouflage Pattern on 30 September 2019, though UCP remains in service in limited capacities such as on some cold weather overgear and older body armor.Operation Enduring Freedom Pattern (MultiCam)
Beginning in late 2010 U.S. Army soldiers deployed to Afghanistan were issued an Army-developed variant of the Crye Precision "MultiCam" pattern, known as the Operation Enduring Freedom Pattern, which was far more effective for use in Afghanistan's terrain. The flame-retardant variants of the uniforms are designed to prevent third-degree burns, along with up to thirty percent of second degree burns. Additionally, all uniforms are treated with the chemical permethrin to help protect soldiers from insect-borne diseases like malaria. Some U.S. Army soldiers during the latter stages of the Iraq War also wore the OEF patterned ACU; some were seen wearing them as late as December 2011, when the United States withdrew its military forces from the country at the end of the war. The MultiCam-patterned ACUs were retired in 2019 with the UCP-patterned ones.Operational Camouflage Pattern (OCP)
In May 2014, the Army unofficially announced that the Operational Camouflage Pattern would replace UCP on the ACU. The original "Scorpion" pattern was developed at United States Army Soldier Systems Center by Crye Precision in 2002 for the Objective Force Warrior program. Crye later modified and trademarked their version of the pattern as MultiCam, which was selected for use by U.S. soldiers and airmen in Afghanistan in 2010 as the Operation Enduring Freedom Pattern. After talks to officially adopt MultiCam broke down over costs in late 2013, the Army began experimenting with the original Scorpion pattern, creating a variant code named "Scorpion W2", noting that while a pattern can be copyrighted, a color palette cannot and that beyond 50 meters the actual pattern is "not that relevant." The pattern resembles MultiCam with muted greens, light beige, and dark brown colors, but uses fewer beige and brown patches and no vertical twig and branch elements. On 31 July 2014, the Army formally announced that the pattern would begin being issued in uniforms in summer 2015. The official name is intended to emphasize its use beyond Afghanistan to all combatant commands. The OCP pattern fully replaced the UCP pattern on the ACU by 1 October 2019. ACUs printed in OCP first became available for purchase on 1 July 2015, with deployed soldiers already being issued uniforms and equipment in the new pattern.The Air Force has also started to adopt the OCP Uniform from 2018 onward, with it slated to replace the Airman Battle Uniform by April 2021.
The U.S. Space Force has also adopted the OCP uniform, but with navy blue thread for ranks and tapes.
Components
The ACU features hook-and-loop fasteners, also known by the genericized trademark Velcro, on its sleeve pockets.Blouse
The ACU jacket originally used hook-and-loop-backed attachments to secure items such as name tapes, rank insignia, and shoulder patches and tabs, as well as recognition devices such as the U.S. flag patch and the infrared tab. Originally only pin-on skill badges were authorized for wear on the ACU, with no more than 5 at any one time.In the summer of 2011, regulations were changed to allow for wearing of sew-on embroidered skill badges. The 5-badge limit remained in effect, and there could be no mixing of sew-on and pin-on badges. At the same time, the branch tape, name tapes, and rank insignia could be sewn-on at the wearers preference. Skill tabs, such as the President's Hundred Tab, Special Forces, Ranger, and Sapper are worn on the left sleeve pocket flap, and are subject to a 3-tab-only rule. A tab that is an integral part of a unit patch, such as the "Mountain" or "Airborne" tab, is not counted against the rule. The U.S. Army Chaplain insignia is the only authorized army branch insignia to be worn on the ACU. It is centered 1/8 inch above the right name tape. The insignia may be the metal pin-on variety or the black embroidered insignia on digitized fabric with Velcro fasteners.
Near Infrared Signature Management Technology is incorporated to minimize the infrared silhouette. Permanent IR IFF squares are sewn to each shoulder to help identify friendly personnel when night vision devices are used, and are protected by Velcro tabs in garrison or when not in use.
Three U.S. flag insignia are authorized for wear with the ACU: full-color, full-color infrared, and subdued infrared. The U.S. flag insignia is worn on the right shoulder pocket flap of the ACU coat. The subdued version is only worn as directed under tactical or field conditions in the Army, while the Air Force only authorizes the subdued flag. Subdued shoulder sleeve insignia are worn.
The jacket's Mandarin collar was intended to be worn up in combat to fit with the Improved Outer Tactical Vest body armor, and worn in the down position otherwise. With the change of pattern to OCP, the Velcro tab that closed the Mandarin collar was removed, along with other Velcro closures.
The front closure is zippered and reinforced with Velcro, designed for use with OTV. The tilted chest pockets, cuffs, and elbow pad insert pockets also utilize hook-and-loop closure. There is a three slot pen pocket on the left arm of the jacket, and blouse bellows for increased mobility. The jacket is worn so that its bottom is between the bottom of the pocket and the top of the cargo pocket.
In the field, the jacket may be replaced by the flame resistant Army Combat Shirt when worn directly under the IOTV.
Trousers
The ACU trousers are worn with a two-inch nylon web belt, and feature Velcro pouches for knee pad inserts, two forward-tilted thigh storage pockets with elastic drawstring and Velcro for closure during movement, and two calf storage pockets one on each pant leg with a Velcro closure. ACU trousers with flame resistant materials are being issued for use in Iraq and Afghanistan.The updates to the ACU trousers in late 2010 included removal of Velcro fasteners from forward-tilted thigh cargo pocket flaps which were replaced with 3 buttons. This change was introduced gradually from 2009 onward and is now in full effect. Two buttons are standard, while the third button located at the very end of the pocket can be used to allow for more load and extra volume in cargo pockets. On the small calf pockets the 3-piece Velcro have been replaced with a single button in 2012. Buttons were re-introduced and replaced Velcro on pockets after numerous complaints from soldiers in the field.
The belt loops are of new design. The width has doubled, and there are now 8 of them compared to 7 in the past. The waist adjustment cord has been removed and replaced by the Velcro waistband fine-adjusters, one at each hip. Instead of a knee pocket which could only accommodate soft knee inserts in the past, the knee area now features multi-layered comprehensive design which allows external hard-type knee pads to be inserted and secured. Back of the knee area has Velcro hook and loop patches to further secure knee inserts around the knee area. Cuffs at the bottom of the trousers do not use drawstrings anymore for blousing; those have been again replaced by the Velcro cuff adjusters. Further changes as part of the transition to OCP removed the pockets for insertable knee pads altogether, along with the replacement of more Velcro with buttons.
To be able to differentiate the Fire-Retardant ACU from the regular ACU at a distance, a small square inch tan patch is affixed to the left sleeve cuff on the jacket and the middle of the left cargo pocket flap on the trousers.