Alkalinity


Alkalinity is the capacity of water to resist changes in pH that would make the water more acidic. Alkalinity is the strength of a buffer solution composed of weak acids and their conjugate bases. It is measured by titrating the solution with a monoprotic acid such as HCl until its pH changes abruptly, or it reaches a known endpoint where that happens. Alkalinity is expressed in units of meq/L , which corresponds to the amount of monoprotic acid added as a titrant in millimoles per liter.
Although alkalinity is primarily a term invented by oceanographers, it is also used by hydrologists to describe temporary hardness. Moreover, measuring alkalinity is important in determining a stream's ability to neutralize acidic pollution from rainfall or wastewater. It is one of the best measures of the sensitivity of the stream to acid inputs. There can be long-term changes in the alkalinity of streams and rivers in response to human disturbances.

History

In 1884, Professor Wilhelm Dittmar of Anderson College, now the University of Strathclyde, analysed 77 pristine seawater samples from around the world brought back by the Challenger expedition. He found that in seawater the major ions were in a fixed ratio, confirming the hypothesis of Johan Georg Forchhammer, that is now known as the Principle of Constant Proportions. However, there was one exception. Dittmar found that the concentration of calcium was slightly greater in the deep ocean, and named this increase alkalinity.
1884 was also the year when Svante Arrhenius submitted his PhD theses in which he advocated the existence of ions in solution, and defined acids as hydronium ion donors and bases as hydroxide ions donors. For that work, he received the Nobel Prize in Chemistry in 1903.

Simplified summary

Alkalinity roughly refers to the amount of bases in a solution that can be converted to uncharged species by a strong acid. The cited author, James Drever, provides an equation expressed in terms of molar equivalents, which means the number of moles of each ion type multiplied by the charge of the ion. For example, 1 mole of HCO31− in solution represents 1 molar equivalent, while 1 mole of CO32− is 2 molar equivalents because twice as many H+ ions would be necessary to balance the charge. The total charge of a solution always equals zero.
Quoting from page 52, "Ions such as Na+, K+, Ca2+, Mg2+, Cl, SO42−, and NO3 can be regarded as "conservative" in the sense that their concentrations are unaffected by changes in the pH, pressure, or temperature."
On the left-hand side of the equation is the sum of conservative cations minus the sum of conservative anions. Balancing this on the right side is the sum of the anions that could be neutralized by added H+ ions minus H+ ions already present, as indicated by the pH. All numbers are molar equivalents.
This right side term is called total alkalinity. It is, quoting Drever, "formally defined as the equivalent sum of the bases that are titratable with strong acid ". The listing of ions shown on the right in Drever was "mHCO3 + 2mCO32− + mB4 + mH34 + mHS + morganic anions + mOH - mH+". Total alkalinity is measured by adding a strong acid until all the anions listed above are converted to uncharged species. The total alkalinity is not affected by temperature, pressure, or pH, though the values of individual constituents are, mostly being conversions between HCO3 and CO32−.
Drever further notes that in most natural waters, all anions except HCO3 and CO32− have low concentrations. Thus carbonate alkalinity, which is equal to mHCO3 + 2mCO32− is also approximately equal to the total alkalinity.

Detailed description

Alkalinity or AT measures the ability of a solution to neutralize acids to the equivalence point of carbonate or bicarbonate. The alkalinity is equal to the stoichiometric sum of the bases in solution. In the natural environment carbonate alkalinity tends to make up most of the total alkalinity due to the common occurrence and dissolution of carbonate rocks and presence of carbon dioxide in the atmosphere. Other common natural components that can contribute to alkalinity include borate, hydroxide, phosphate, silicate, dissolved ammonia, the conjugate bases of some organic acids, and sulfate. Solutions produced in a laboratory may contain a virtually limitless number of bases that contribute to alkalinity. Alkalinity is usually given in the unit mEq/L. Commercially, as in the swimming pool industry, alkalinity might also be given in parts per million of equivalent calcium carbonate.
Alkalinity is sometimes incorrectly used interchangeably with basicity. For example, the addition of CO2 lowers the pH of a solution. This increase reduces the basicity; however, the alkalinity remains unchanged. For total alkalinity testing, N/10 H2SO4 is used by hydrologists along with phenolphthalein indicator.

Theoretical treatment

In typical groundwater or seawater, the measured alkalinity is set equal to:
Alkalinity can be measured by titrating a sample with a strong acid until all the buffering capacity of the aforementioned ions above the pH of bicarbonate or carbonate is consumed. This point is functionally set to pH 4.5. At this point, all the bases of interest have been protonated to the zero level species, hence they no longer cause alkalinity. In the carbonate system the bicarbonate ions and the carbonate ions have become converted to carbonic acid at this pH. This pH is also called the CO2 equivalence point where the major component in water is dissolved CO2 which is converted to H2CO3 in an aqueous solution. There are no strong acids or bases at this point. Therefore, the alkalinity is modeled and quantified with respect to the CO2 equivalence point. Because the alkalinity is measured with respect to the CO2 equivalence point, the dissolution of CO2, although it adds acid and dissolved inorganic carbon, does not change the alkalinity. In natural conditions, the dissolution of basic rocks and addition of ammonia or organic amines leads to the addition of base to natural waters at the CO2 equivalence point. The dissolved base in water increases the pH and titrates an equivalent amount of CO2 to bicarbonate ion and carbonate ion. At equilibrium, the water contains a certain amount of alkalinity contributed by the concentration of weak acid anions. Conversely, the addition of acid converts weak acid anions to CO2 and continuous addition of strong acids can cause the alkalinity to become less than zero. For example, the following reactions take place during the addition of acid to a typical seawater solution:
It can be seen from the above protonation reactions that most bases consume one proton to become a neutral species, thus increasing alkalinity by one per equivalent. CO3−2 however, will consume two protons before becoming a zero level species, thus it increases alkalinity by two per mole of CO3−2. and decrease alkalinity, as they act as sources of protons. They are often represented collectively as T.
Alkalinity is typically reported as mg/L as CaCO3. This can be converted into milliEquivalents per Liter by dividing by 50.

Example problems

Sum of contributing species

The following equations demonstrate the relative contributions of each component to the alkalinity of a typical seawater sample. Contributions are in μmol.kg−soln−1 and are obtained from A Handbook of Methods for the analysis of carbon dioxide parameters in seawater ",".
Phosphates and silicate, being nutrients, are typically negligible. At pH = 8.1 and are also negligible. So,

Addition of CO2

Addition of CO2 to a solution does not change its alkalinity, since the net reaction produces the same number of equivalents of positively contributing species as negative contributing species. Adding CO2 to the solution lowers its pH, but does not affect alkalinity.
At all pH values:
Only at high pH values:

Dissolution of carbonate rock

Addition of CO2 to a solution in contact with a solid can affect the alkalinity, especially for carbonate minerals in contact with groundwater or seawater. The dissolution of carbonate rock has a strong influence on the alkalinity. This is because carbonate rock is composed of CaCO3 and its dissociation will add Ca+2 and CO3−2 into solution. Ca+2 will not influence alkalinity, but CO3−2 will increase alkalinity by 2 units. Increased dissolution of carbonate rock by acidification from acid rain and mining has contributed to increased alkalinity concentrations in some major rivers throughout the Eastern U.S. The following reaction shows how acid rain, containing sulfuric acid, can have the effect of increasing river alkalinity by increasing the amount of bicarbonate ion:
Another way of writing this is:
The lower the pH, the higher the concentration of bicarbonate will be. This shows how a lower pH can lead to higher alkalinity if the amount of bicarbonate produced is greater than the amount of H+ remaining after the reaction. This is the case since the amount of acid in the rainwater is low. If this alkaline groundwater later comes into contact with the atmosphere, it can lose CO2, precipitate carbonate, and thereby become less alkaline again. When carbonate minerals, water, and the atmosphere are all in equilibrium, the reversible reaction
shows that pH will be related to calcium ion concentration, with lower pH going with higher calcium ion concentration. In this case, the higher the pH, the more bicarbonate and carbonate ion there will be, in contrast to the paradoxical situation described above, where one does not have equilibrium with the atmosphere.

Oceanic alkalinity

Processes that increase alkalinity

There are many methods of alkalinity generation in the ocean. Perhaps the most well known is the dissolution of CaCO3 to form Ca2+ and CO32−. The carbonate ion has the potential to absorb two hydrogen ions. Therefore, it causes a net increase in ocean alkalinity. Calcium carbonate dissolution is an indirect result of ocean pH lowering. It can cause great damage to coral reef ecosystems, but has a relatively low effect on the total alkalinity in the ocean. Lowering of pH due to absorption of CO2 actually raises the alkalinity by causing dissolution of carbonates.
Anaerobic degradation processes, such as denitrification and sulfate reduction, have a much greater impact on oceanic alkalinity. Denitrification and sulfate reduction occur in the deep ocean, where there is an absence of oxygen. Both of these processes consume hydrogen ions and releases quasi-inert gases, which eventually escape into the atmosphere. This consumption of H+ increases the alkalinity. It has been estimated that anaerobic degradation could be as much as 60% of the total oceanic alkalinity.

Processes that decrease alkalinity

Anaerobic processes generally increase alkalinity. Conversely, aerobic degradation can decrease AT. This process occurs in portions of the ocean where oxygen is present. It results in dissolved organic matter and the production of hydrogen ions. An increase in H+ clearly decreases alkalinity. However, the dissolved organic matter may have base functional groups that can consume these hydrogen ions and negate their effect on alkalinity. Therefore, aerobic degradation has a relatively low impact on the overall oceanic alkalinity.
All of these aforementioned methods are chemical processes. However, physical processes can also serve to affect AT. The melting of polar ice caps is a growing concern that can serve to decrease oceanic alkalinity. If the ice were to melt, then the overall volume of the ocean would increase. Because alkalinity is a concentration value, increasing the volume would theoretically serve to decrease AT. However, the actual effect would be much more complicated than this.

Global temporal variability

Researchers have shown oceanic alkalinity to vary over time. Because AT is calculated from the ions in the ocean, a change in the chemical composition would alter alkalinity. One way this can occur is through ocean acidification. However, oceanic alkalinity is relatively stable, so significant changes can only occur over long time scales. As a result, seasonal and annual variability is generally very low.

Spatial variability

Researchers have also shown alkalinity to vary depending on location. Local AT can be affected by two main mixing patterns: current and river. Current dominated mixing occurs close to the shore in areas with strong water flow. In these areas, alkalinity trends follow current and have a segmented relationship with salinity.
River dominated mixing also occurs close to the shore; it is strongest close to the mouth of a large river. Here, the rivers can act as either a source or a sink of alkalinity. AT follows the outflow of the river and has a linear relationship with salinity. This mixing pattern is most important in late winter and spring, because snowmelt increases the river’s outflow. As the season progresses into summer, river processes are less significant, and current mixing can become the dominant process.
Oceanic alkalinity also follows general trends based on latitude and depth. It has been shown that AT is often inversely proportional to sea surface temperature. Therefore, it generally increases with high latitudes and depths. As a result, upwelling areas also have higher alkalinity values.

Measurement data sets

Throughout recent history, there have been many attempts to measure, record, and study oceanic alkalinity. Some of the larger data sets are listed below.
  • GEOSECS
  • TTO/NAS
  • JGOFS
  • WOCE
  • CARINA

    Carbonate system calculators

The following packages calculate the state of the carbonate system in seawater :